Hi list,
I'm writing a lot lately, lol.
About my question: I had the strangest experience that I have
never had before today. I was conditioning my battery by letting
it run down to critical level and then plugging it in. I
successfully plugged it in, went to do some things around the
house, and came back about 30 minutes later to see where it was
at, and it said, battery level 0%, adapter on. How strange. I
just got it replaced along with the board chip replaced as well.
Anyway, so I unplugged it and was about to plug it back in, when
it said, AC adapter off, as usual, and it didn't even get to
finish saying the word adapter, before it shut off. Keep in
mind, the battery was only at 3 percent when I plugged it in, so
why did it keep discharging after I plugged it in? It said
discharging when I went into support information mode and pressed
s. It seems to be charging fine now that I turned it back on
after the adapter was plugged in. I did, however, have to reset
the clock as usual when the battery runs flat completely. This
is a new experience. I have let it run flat on accident several
times and did reset the clock, but never has it kept discharging
after the adapter was connected.
Kerri
___
Replies to this message will go directly to the sender.
If your reply would be useful to the list, please send a
copy to the list as well.
To leave the BrailleNote list, send a blank message to
[EMAIL PROTECTED]
To view the list archives or change your preferences, visit
http://list.humanware.com/mailman/listinfo/braillenote
