Hideyuki Hayashi <[email protected]> writes: > On Fri, 19 Jun 2009 16:51:11 +0200 > Mario Lang <[email protected]> wrote: >> Does this machine have several serial ports? If so, did you try to >> connect the cable to the other one as well? > > No, this box has only 1 serial port. > >> Can you check "dmesg" output to make sure the kernel did not report any >> errors during initialisation of the serial port? >> >> I have output like this: >> [ 0.971073] serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A >> [ 0.971659] 00:08: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A > > My case is: > > [ 1.469295] Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ > sharing enabled > [ 1.469450] serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A > [ 1.470113] 00:09: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A > [ 1.470312] serial 0000:00:1f.6: enabling device (0000 -> 0001)
Hmm, this looks fine. I seem to be out of ideas. Do you have any other serial devices you could test the port with? Does your braille display have several connectivity possibilities, like USB and serial, or serial and bluetooth? Maybe you set it to use the other port (this can happen with a few devices I know, like the HandyTech Braille Star or the ALVA Braille Controller). -- CYa, ⡍⠁⠗⠊⠕ | Debian Developer <URL:http://debian.org/> .''`. | Get my public key via finger mlang/[email protected] : :' : | 1024D/7FC1A0854909BCCDBE6C102DDFFC022A6B113E44 `. `' `- <URL:http://delysid.org/> <URL:http://www.staff.tugraz.at/mlang/> _______________________________________________ This message was sent via the BRLTTY mailing list. To post a message, send an e-mail to: [email protected] For general information, go to: http://mielke.cc/mailman/listinfo/brltty
