>>>>> vince h writes:
vh> For booting to windows i must have this order hd2 hd0 hd1 (scsi
vh> ide0 ide1) else windows dont see all dos partitions.
This is a FAQ, and explained in the GRUB manual (grub)DOS/Windows:
DOS/Windows
-----------
GRUB doesn't support booting DOS or Windows directly, so you must
chain-load them (*note Chain-loading::). However, their boot loaders
have some critical deficiencies, so the general methods may not be
enough.
If you have installed DOS (or Windows) on a non-first hard disk, you
have to use the disk swapping technique, because that OS cannot boot
from any disks but the first one. The solution used in GRUB is the
command `map' (*note Commands::), like this:
grub> map (hd0) (hd1)
grub> map (hd1) (hd0)
This performs a "virtual" swap between your first and second hard
drive.
*Caution:* This is effective only if DOS (or Windows) uses BIOS to
access the swapped disks. If it uses a special driver for them, it
probably won't work.
[...]
--
Gordon Matzigkeit <[EMAIL PROTECTED]> //\ I'm a FIG (http://fig.org/)
Committed to freedom and diversity \// I use GNU (http://www.gnu.org/)
