Steve Underwood escreveu:
> Hi Paulo,
>
> The 1 or 0 should be the first dialed digit. Perhaps the other end does
> not accept number beginning with a 1? In the working case the other end
> asks for the ANI digits after the category. In the failed case it asks
> for the dialed digits. However Unicall doesn't respond. Is that because
> its in one of these "time out to end the digits" modes.
>
> It looks like the far end of these two E1s behaves differently. Can you
> swap them over for a test, or is this a heavy production setup? Also,
> can you send me the software versions you are using, and the Unicall
> config files.
>
> Steve
>
Thanks Steve, I figured out the problem, it wasn't callweavers fault.
Embratel (the telco) was blocking dialout on all channels but UniCall/1,
and this channel wasn't being charged - they do this for testing when
installing the trunk. The tech guy forgot to switch it to normal
operation and callweaver starts dialing from the last channels when
Dial(UniCall/g1/${EXTEN}), so I was never dialing through channel 1.
I'm so lame, so dumb, 3 weeks recompiling everything, beating the head
against the wall...
Thanks again!
--
Paulo
_______________________________________________
Callweaver-users mailing list
[email protected]
http://lists.callweaver.org/mailman/listinfo/callweaver-users
