Hi All,

I'm working in an application where I need high frequency resolution
(~10kHz). For my model this means I need to run my ADC at ~40MHz (and the
FPGA at 5MHz). I'm not using an special memory block, just brams. I'm using
ROACH2, and ADC5G (https://casper.berkeley.edu/wiki/ADC1x5000-8). It is
possible to run the ADC at such low frequency? What is the minimum
acceptable frequency? I tried to find this information in  the ADC
datasheet, but I haven't been successful. Also tried compiling simple
models at low frequencies, but everything below 600MHz failed.

Thanks,

Franco

-- 
You received this message because you are subscribed to the Google Groups 
"[email protected]" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
To post to this group, send email to [email protected].

Reply via email to