Hey Franco Many of the CASPER blocks were updated a while ago so that you can use them asynchronously i.e data does not need to be fed to the blocks on every clock cycle. You can then run your FPGA at a higher clock rate than the input data rate.
Regards Andrew On Tue, Apr 4, 2017 at 4:22 AM, Franco <[email protected]> wrote: > Hi All, > > I'm working in an application where I need high frequency resolution > (~10kHz). For my model this means I need to run my ADC at ~40MHz (and the > FPGA at 5MHz). I'm not using an special memory block, just brams. I'm using > ROACH2, and ADC5G (https://casper.berkeley.edu/wiki/ADC1x5000-8). It is > possible to run the ADC at such low frequency? What is the minimum > acceptable frequency? I tried to find this information in the ADC > datasheet, but I haven't been successful. Also tried compiling simple > models at low frequencies, but everything below 600MHz failed. > > Thanks, > > Franco > > > > -- > You received this message because you are subscribed to the Google Groups " > [email protected]" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To post to this group, send email to [email protected]. > -- You received this message because you are subscribed to the Google Groups "[email protected]" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected].

