Hi,
It is difficult to say what is going on looking just at this plot.
I suggest to include a SNAP block into your design and collect raw data in
the time domain, that will give an idea about the signal. You can do an FFT
using Python or Matlab and compare with your spectrometer output.

Most probably you are already aware of those ADC5g design particularities,
but these are the things I would check in the design :
1. ADC5g is an interleaved 4-ADC core, which means that needs to be offset,
gain and phase calibrated. Although this is required to get a good
performance, I do not thing that this is causing such distortions in the
signal.
2, ADC5g output creates 16 eight-bit time-sequential offset-binary samples
at each FPGA clock (it can even be configured to get the signal codified in
Gray code). In most of the cases the signal needs to be converted to
regular signed-binary (CA2) before going further into the digital
processing chain.

Good luck,
XB









On Wed, Aug 23, 2017 at 4:08 AM Siddharth Savyasachi Malu <
[email protected]> wrote:

> Dear CASPERites,
>
> We are trying tut3(spectrometer) using adc5g(ADC 5G V2.0 DMUX1:1) on
> ROACH2 at 300MHz bandwidth. But the output spectrum shows multiple peak for
> a single tone input.
>
> Could you please tell us whether the issue may be related to the 5gsps ADC
> card or the casper adc5g block?
>
> Please find attached output spectrum for 300MHz bandwidth and 100MHz input
> tone signal.
>
> Many thanks,
> Siddharth Malu
> Bela Dixit
> --
> Centre of Astronomy
> Indian Institute of Technology Indore
> Indore, India
> email: [email protected]
>
> --
> You received this message because you are subscribed to the Google Groups "
> [email protected]" group.
> To unsubscribe from this group and stop receiving emails from it, send an
> email to [email protected].
> To post to this group, send email to [email protected].
>

-- 
You received this message because you are subscribed to the Google Groups 
"[email protected]" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
To post to this group, send email to [email protected].

Reply via email to