Can you tell us a bit more? What is your sampling clock frequency? What level are you putting into the ADC input? Can you replot this with frequency on the X axis? It would be good to see if the peaks you see are related to the sampling clock and the input tone in some way, i.e. are they intermodulation products.
Try turning down the input tone level (quite) a bit to be sure you are not saturating the ADC. I agree with Xavier that it's probably not the yellow block, although it's possible you have a defective ADC. Try substituting if you have another one. Your FFT shift should shift every stage probably fr a tone input. Every other for noise+ tone. Xavier's other suggestion to put in some snap blocks at the beginning of the processing chain so that you can see the raw samples is a good one. I think this is something that should always be done in any design. (and you need them later to do the calibration properly!). Hope this helps! John On Wed, Aug 23, 2017 at 4:08 AM, Siddharth Savyasachi Malu < [email protected]> wrote: > Dear CASPERites, > > We are trying tut3(spectrometer) using adc5g(ADC 5G V2.0 DMUX1:1) on > ROACH2 at 300MHz bandwidth. But the output spectrum shows multiple peak for > a single tone input. > > Could you please tell us whether the issue may be related to the 5gsps ADC > card or the casper adc5g block? > > Please find attached output spectrum for 300MHz bandwidth and 100MHz input > tone signal. > > Many thanks, > Siddharth Malu > Bela Dixit > -- > Centre of Astronomy > Indian Institute of Technology Indore > Indore, India > email: [email protected] > > -- > You received this message because you are subscribed to the Google Groups " > [email protected]" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To post to this group, send email to [email protected]. > -- You received this message because you are subscribed to the Google Groups "[email protected]" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected].

