Hi. I'm not sure exactly what your question is, but on the face of it there are 3 nets that don't meet timing, due to routing problems. What frequency are you building the FPGA fabric at? Have you tried just one ADC to see if it routes OK? How full is the FPGA with your design? You may be able to use planahead to manually place some parts to allow these nets to meet timing. I don't know if there's anything in hte yellow block settings that might help this. You might want to load this into timing analyzer and see where the problems lie.
John On Fri, Sep 1, 2017 at 3:29 AM, Anshu Singh <[email protected]> wrote: > Hi, > > The detailed error report is attached herewith. > > On Fri, Sep 1, 2017 at 3:50 PM, Anshu Singh <[email protected]> > wrote: > >> Hi Everyone, >> >> I am trying to use 2 quadADC (ADC4*250) with ROACH board simultaneously. >> While compiling, I am getting a timing error.The screen shot is attached >> in this mail. >> >> >> Could someone please let me know the issue? >> >> >> Thanks, >> Anshu >> >> > > > -- > -------------------------- > Anshu > Junior Research Fellow > (Int. M.tech-Ph.D Batch 2013) > Indian Institute of Astrophysics > Koromangala II Block > Bangalore-560034 > > -- > You received this message because you are subscribed to the Google Groups " > [email protected]" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To post to this group, send email to [email protected]. > -- You received this message because you are subscribed to the Google Groups "[email protected]" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected].

