Hi Anshu,

To add to John's comments -- this isn't an "error" in the sense there's
anything wrong with your code or the tools. It's a failure of the Xilinx
placer/router to find a way of implementing your design which will run at
the speed you requested (250 MHz(?)).
Probably these are specific parts of your design which are causing problems
(either components with low latency, or signals which fan-out to multiple
places). Fixing this is a bit of a black art -- there is a Xilinx Timing
Closure Guide, and some notes on the wiki (see
https://casper.berkeley.edu/wiki/Tutorial_PlanAhead) but basically it
begins by looking at the timing report generated by the tools --
<compil_directory>/XPS_ROACH2_base/implementation/system.twr -- which is a
slightly cryptic reporting of which components are problematic.
Making your design smaller or lowering the clock speed, if either of these
options is acceptable, will also help.

Cheers
Jack

On Fri, 1 Sep 2017 at 08:55 John Ford <[email protected]> wrote:

> Hi.
>
> I'm not sure exactly what your question is, but on the face of it there
> are 3 nets that don't meet timing, due to routing problems.  What frequency
> are you building the FPGA fabric at?  Have you tried just one ADC to see if
> it routes OK?  How full is the FPGA with your design?  You may be able to
> use planahead to manually place some parts to allow these nets to meet
> timing.  I don't know if there's anything in hte yellow block settings that
> might help this.   You might want to load this into timing analyzer and see
> where the problems lie.
>
> John
>
>
>
> On Fri, Sep 1, 2017 at 3:29 AM, Anshu Singh <[email protected]>
> wrote:
>
>> Hi,
>>
>> The detailed error report is attached herewith.
>>
>> On Fri, Sep 1, 2017 at 3:50 PM, Anshu Singh <[email protected]>
>> wrote:
>>
>>> Hi Everyone,
>>>
>>> I am trying to use 2 quadADC (ADC4*250) with ROACH board simultaneously.
>>> While compiling, I am getting a timing error.The screen shot is attached
>>> in this mail.
>>>
>>>
>>> Could someone please let me know the issue?
>>>
>>>
>>> Thanks,
>>> Anshu
>>>
>>>
>>
>>
>> --
>> --------------------------
>> Anshu
>> Junior Research Fellow
>> (Int. M.tech-Ph.D Batch 2013)
>> Indian Institute of Astrophysics
>> Koromangala II Block
>> Bangalore-560034
>>
>> --
>> You received this message because you are subscribed to the Google Groups
>> "[email protected]" group.
>> To unsubscribe from this group and stop receiving emails from it, send an
>> email to [email protected].
>> To post to this group, send email to [email protected].
>>
>
> --
> You received this message because you are subscribed to the Google Groups "
> [email protected]" group.
> To unsubscribe from this group and stop receiving emails from it, send an
> email to [email protected].
> To post to this group, send email to [email protected].
>

-- 
You received this message because you are subscribed to the Google Groups 
"[email protected]" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
To post to this group, send email to [email protected].

Reply via email to