Hi Nivek, I would take a read through this https://raspberrypi.stackexchange.com/questions/19354/raspberry-pi-with-boots-up-with-rainbow-screen
Also confirm that you have a power supply that can deliver 2.5A at 5v. I have not used that image before, but you can plug the card into your PC and check if it mounts correctly and the boot partition is there. Wesley New South African SKA Project +2721 506 7300 www.ska.ac.za On Wed, Aug 29, 2018 at 12:21 PM, Nivek Ghazi <nivekgh...@outlook.com> wrote: > Hey Casper people, > > So, I recently got a raspberry pi 3 b+ and looking to get it working > with the SNAP board. I've download the image from the SNAP bringup > tutorial and tried to get it to boot but it fails (the raspberry pi > basically just outputs a rainbow pattern on the monitor with the red > power led on and stays there). I'm guessing it fails because the image > was not compiled to run on this new raspberry pi. Is it possible to get > the raspberry pi 3 b+ working with the SNAP board? > > thanks, > > Nivek Ghazi > > -- > You received this message because you are subscribed to the Google Groups " > casper@lists.berkeley.edu" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to casper+unsubscr...@lists.berkeley.edu. > To post to this group, send email to casper@lists.berkeley.edu. > -- You received this message because you are subscribed to the Google Groups "casper@lists.berkeley.edu" group. To unsubscribe from this group and stop receiving emails from it, send an email to casper+unsubscr...@lists.berkeley.edu. To post to this group, send email to casper@lists.berkeley.edu.
