Hello:
I have a question related to section 34
configure the EIGRP process to drop routes from inactive neighbors after half
of the default value
based on Cisco doc. There are two hold time available for that, NSF time is
only for NSF-aware routers.
should "ip hold-time eigrp" be the answer for this question?
thanks,
~ml
timers nsf route-hold
To set the route-hold timer to determine how long an NSF-aware router that is
running EIGRP will hold routes for an inactive peer, use the timers nsf
route-hold command in router configuration mode. To return the route-hold timer
to the default value, use the no form of this command.
ip hold-time eigrp
To configure the hold time for a particular Enhanced Interior Gateway Routing
Protocol (EIGRP) routing process designated by the autonomous system number,
use the ip hold-time eigrp command in interface configuration mode. To restore
the default value, use the no form of this command.
_________________________________________________________________
Don't get caught with egg on your face. Play Chicktionary!
http://club.live.com/chicktionary.aspx?icid=chick_wlhmtextlink1_dec
