Hi scott,
Hi group,
I have just finished lab 10, however I would like, if possible,
get a bit elucidation, namely in task 10.9 you tell "every router
should see all route in their routing table and have full
reachability to these addresses"
The situation was follow
R7 can`t see 2000:1:1:26::6, therefore don`t forward any packet
to R2,
same thing for R1
As weel I redistribuited also the connected,namely ipv6 address
configured to tunnel and fast eth 0/0 on R6, because it has two
different process routing, but why do you included also loopback
of R6 in about it? I needed because....
I can reach L0 of R6 from R1:
R1#pi 2000:1:1:6600:20A:B8FF:FE19:AB78
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to
2000:1:1:6600:20A:B8FF:FE19:AB78, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max =
52/52/52 ms
Thanks a lot for your reply.
--
This message is intended for the individual(s) to whom it is addressed and may
contain information that is privileged or confidential.
If you are not the addressee you must not read,use or disclose the contents of
this email.
Whilst all reasonable care has been taken to avoid the transmission of viruses,
the recipient should carry out virus and other checks,
as they consider appropriate.
Myself accepts no responsibility in this regard.
