Hi there,
Can anyone help me please, bout these questions?
volume #1 (9.16)
without using the "bandwidth" command or changing any configuration under a
routing process on any router, ensure that R2 uses the PVC TO R5 to reach
any network connected
to R7 or R8 after a reload of R2 occurs.
tha answer is:
router eigrp 1001
maximum-paths 1 ----- what does that mean ?
volume # (9.17)
Configure R5 so that the EIGRP process can use 43% of the bandwidth on the
serial interfaces?
R2 # int s0/2/0
ppp lcp delay 200 discard --------> what does this command mean ?
by the way this command is not available at GNS3 sumilator.
volume # (9.18)
configure R4 so that EIGRP will use onley 37.5% of the frame-relay link's
bandwidth. Do not use an EIGRP interface-based command on R4 to accomplish
this.
the answer is:
int s0/0/0
bandwidth 48 -----------> how did they came up with this number ?
volume # (9.6)
make R5's route table for 100.100.100.0 have varying traffic share counts,
R7's route table should have a traffic share count of "1".
R5
router rigrp 1001 -------> what does this command mean ?
vriance 2
thanks,
khaled
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
