Hi there, can anyone help me with this matter?
---------- Forwarded message ---------- From: khaled al-ajeman <[email protected]> Date: Mon, Nov 15, 2010 at 2:39 PM Subject: I have questions about volume#1 To: [email protected] Hi there, Can anyone help me please, bout these questions? volume #1 (9.16) without using the "bandwidth" command or changing any configuration under a routing process on any router, ensure that R2 uses the PVC TO R5 to reach any network connected to R7 or R8 after a reload of R2 occurs. tha answer is: router eigrp 1001 maximum-paths 1 ----- what does that mean ? volume # (9.17) Configure R5 so that the EIGRP process can use 43% of the bandwidth on the serial interfaces? R2 # int s0/2/0 ppp lcp delay 200 discard --------> what does this command mean ? by the way this command is not available at GNS3 sumilator. volume # (9.18) configure R4 so that EIGRP will use onley 37.5% of the frame-relay link's bandwidth. Do not use an EIGRP interface-based command on R4 to accomplish this. the answer is: int s0/0/0 bandwidth 48 -----------> how did they came up with this number ? volume # (9.6) make R5's route table for 100.100.100.0 have varying traffic share counts, R7's route table should have a traffic share count of "1". R5 router rigrp 1001 -------> what does this command mean ? vriance 2 thanks, khaled
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
