You have to disable inverse arp on the physical interface only, not sure if you did that. You may try to clear It out using "clear frame inarp" and then run a "show frame map" if they are still showing up go under int s0/1/0 and issue the no frame-relay inverse-arp command and reload
HTH Thank you. Steve Di Bias Network Engineer - Information Systems Valley Health System - Las Vegas Office - 702- 369-7594 Cell - 702-241-1801 [email protected] -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Alef Sent: Wednesday, March 02, 2011 11:14 PM To: CC IE Subject: [OSL | CCIE_RS] PVC mappings won't go away / already there Hi, In Vol1, Lab1, page 25 i try to assign dlci 204 but it always gives up this command. Doing a show frame-relay pvc shows that it is indeed already in use. I have gone ahead and put no frame-relay inverse-arp on all FR interfaces (which does not show up in the config by the way), and reload all routers with FR interfaces (no easier way to clear pvc mappings?) but still i get this message. Anyone got any suggestions ? R2(config)#int Serial0/1/0.24 R2(config-subif)#frame-relay interface-dlci 204 %PVC already assigned to interface Serial0/1/0 Kind regards, Alef _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com UHS Confidentiality Notice: This e-mail message, including any attachments, is for the sole use of the intended recipient (s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution of this information is prohibited. If this was sent to you in error, please notify the sender by reply e-mail and destroy all copies of the original message. _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
