Looking at the DSG they have removed telnet only allowing ssh so you were correct in your thinking
"Di Bias, Steve" <[email protected]> wrote: That's what I would do, or maybe ask the proctor as you suggested. So that begs a good question for which I don't have an answer. Which on is correct on the cats Line vty 0 4 Transport input telnet ssh Or Transport input ssh What does it show in the DSG? Aaron Moreck <[email protected]> wrote: I am in the middle of Lab 17 and could use some clarification. Question 1.1 "Configure your VTY lines o all devices so they can be reached by telnet" Question 2.2 "Remote access sessions on both switches must be secured and encrypted" These seem like conflicting questions. I am assuming that i am to follow the more restrictive requirement and configure ssh only on CAT 1 and CAT 2 while allowing telnet to all other devices. _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com UHS Confidentiality Notice: This e-mail message, including any attachments, is for the sole use of the intended recipient (s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution of this information is prohibited. If this was sent to you in error, please notify the sender by reply e-mail and destroy all copies of the original message. _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
