Hi Steve, I believe technically it would, but there is no other way around it. You need to achieve that target rate, and the calculated values are derived of that. I believe in my lab excess traffic burst was set to 0 as well, and altered too. Nothing you can do about it.
Alef > > Content-Type: text/plain; charset="us-ascii" > > Hey Experts! > > In Volume 1 Task 23.4 we are asked to configure GTS and shouldn't allow > excess traffic bursts > > The way I interpreted this is that we need to configure excess as a "0", does > that sound right? For example, if we only configure the target bit rate, the > other values will be automagically configured for us by Cisco IOS. Doesn't > this violate the task? > > > For example the DSG shows the following configuration by just configuring the > target bit rate > > R4(config)#inter s0/1/0.24 > R4(config-subif)# bandwidth 64 > R4(config-subif)# traffic-shape group 101 9600 > R4(config-subif)# traffic-shape group 102 32000 > R4(config-subif)# traffic-shape group 103 22400 > > However let's look at the interface configuration we can see the numbers were > automagically configured which in my eyes vilolates the task > > interface Serial0/1/0.24 point-to-point > bandwidth 64 > ip address 150.50.24.1 255.255.255.252 > traffic-shape group 101 9600 7968 7968 1000 > traffic-shape group 102 32000 8000 8000 1000 > traffic-shape group 103 22400 7952 7952 1000 > > My end config looked like this > > interface Serial0/1/0.24 point-to-point > bandwidth 64 > ip address 150.50.24.1 255.255.255.252 > traffic-shape group 101 9600 7968 0 1000 > traffic-shape group 102 32000 8000 0 1000 > traffic-shape group 103 22400 7952 0 1000 > > If someone can shed some light on this it would be much appreciated! > > _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
