Hi all,Was doing WB3 Lab 7 today. Under task 3.1, which is the IPv4 BGP bit,
we have an instruction: "Use templates for all configuration on R1". Later, we
configure MP-BGP for VPNV4 on R1, and these re-use the templates that are
configured. However, when we come to configure PE-CE BGP on R1, out to the CE,
the DSG uses the syntax: address-family ipv4 vrf R9nei <IP> remote-as 1389eni
<IP> actnei <IP> send-community Em...hasn't this just violated the instruction
to use templates for all BGP configuration on R1??? Which leads me to a general
question: If we are given an instruction for one address family in BGP, should
be assume that this carries over into all other address families as well? A
previos lab had us attach communities to routes in IPv4, and this was carried
over to other address families too. Here, the instruction appears NOT to be
carried over..... Your thoughts? I know...ask the proctor....!! Regards George.
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com
http://onlinestudylist.com/mailman/listinfo/ccie_rs
