bump On 6 September 2012 05:10, Tony Singh <[email protected]> wrote:
> > should mention debug sw-vlan vtp pruning not showing anything, only when > im in client or server mode. > > the reason it needs to be in transparent mode is so that I don't break > task 3.2 = switches should no exchange any information over trunks > > > On 6 September 2012 04:06, Tony Singh <[email protected]> wrote: > >> >> Hi Experts >> >> were asked to enable all switches to prune vlans not being used by each >> switch. >> >> ok that's fine server mode then enable pruning then back to transparent >> mode minus the extended vlan problems on cat3/cat4 and now there all back >> to transparent. >> >> sorry might be a dumb question but when I verify the pruning with sh int >> trunk I can see it not pruning even though pruning is enabled in tranparent >> mode - correct behaviour >> >> am i not getting it? do I need to carry on & ignore the verification of >> pruning in trans mode?, read on...? >> >> Tony >> > > _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
