You are correct - pruning does not work in VTP transparent mode. It's one of those pointless exercises to satisfy the required output of "show vtp status", but have no functionality.
-- Marko Milivojevic - CCIE #18427 :: This message was sent from a mobile device. I apologize for errors and brevity. :: On Sep 5, 2012, at 20:06, Tony Singh <[email protected]> wrote: > Hi Experts > > were asked to enable all switches to prune vlans not being used by each > switch. > > ok that's fine server mode then enable pruning then back to transparent > mode minus the extended vlan problems on cat3/cat4 and now there all back > to transparent. > > sorry might be a dumb question but when I verify the pruning with sh int > trunk I can see it not pruning even though pruning is enabled in tranparent > mode - correct behaviour > > am i not getting it? do I need to carry on, read on... > > Tony > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > > http://onlinestudylist.com/mailman/listinfo/ccie_rs _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
