Hi waqar You need to play with the IGP metrics by using offset lists in EIGRP or OSPF cost metrics to achieve the desired results to the destination host addresses, the reason not many people have replied is their isn't enough information that has been provided these types of questions you really need to understand the basics of routing.
Good luck. -- BR Tony Sent from my iPad On 26 Jul 2013, at 23:54, Waqas Daar <[email protected]> wrote: > Hello Team, > > I configure the following topology to play with the routing redistribution. > > I want to achieve the following. > > Routing Redistribution Point are R5, R6 and R11 > > On R5 we are redistributing from RIP to OSPF, EIGRP 200 to OSPF, and from > OSPF to EIGRP 200 and OSPF to RIP. > On R6 I am redistributing from EIGRP 200 into RIP and from RIP into EIGRP > 200. > On R11 from OSPF into EIGRP 200 and from EIGRP 200 into OSPF. > > What I would like to achieve the following > > -> When BB2 try to trace route the loop back of R8 loop back ip address > (8.8.8.8) It should follow the below path > BB2-> R14-> R12 -> R11 -> R7 -> R6 -> R8 > -> When BB1 try to trace route the loop back of R8 loop back ip address > (8.8.8.8) It should follow the below path > BB1->R1->R2 -> R3 -> R5 -> R6 -> R8 > -> When any BB1 or BB2 try to trace route the loopback of R10 it should > follow the below path > R5->R6->R7->R9->R10 > > Your suggestions or input will be highly appreciated. > > Regards, > > Waqas Daar > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > > http://onlinestudylist.com/mailman/listinfo/ccie_rs _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
