You need to configure frame-relay switching in the global config of one of the switches e.g R5 Also configure the serial on that same switch as DCE ---> frame-relay intf-type dce
On Thu, Dec 5, 2013 at 3:20 PM, Danny Alvarez Uribe <[email protected]>wrote: > Thanks man. Then perhaps it's because the clock rate statement is > configured on both ends? Can you post the '"show interface" from each side? > > > On Thu, Dec 5, 2013 at 9:09 AM, rauenpc . <[email protected]> wrote: > > > Being PPPoFR, the serial link needs to remain with encapsulation > > frame-relay. The only way to configure "ppp multilink group 1" would be > to > > first set the encapsulation to ppp on the serial interface. > > > > > > On Thu, Dec 5, 2013 at 8:59 AM, Danny Alvarez Uribe <[email protected] > >wrote: > > > >> Shouldn't Serial0/2/0 also be on ppp multilink group 1 ? > >> > >> - Danny > >> > > > > > _______________________________________________ > Free CCIE R&S, Collaboration, Data Center, Wireless & Security Videos :: > > iPexpert on YouTube: www.youtube.com/ipexpertinc > _______________________________________________ Free CCIE R&S, Collaboration, Data Center, Wireless & Security Videos :: iPexpert on YouTube: www.youtube.com/ipexpertinc
