Assuming everything was spelled correctly, your config looks OK. Is it possible you didn't remove a previous entry? Here's a working example. See if this helps.
FYI "h323-gateway voip bind srcaddr" is only needed if configured as H.323 gateway in CCM. HQ: ========================================================== HQ#sh run | beg gatek gatekeeper zone local HQ-RTR1 ipexpert.com 172.1.100.1 zone remote PSTN-WAN ipexpert.com 10.1.200.4 1719 zone prefix PSTN-WAN 0113433132130* zone prefix HQ-RTR1 011* gw-priority 10 CME zone prefix HQ-RTR1 011* gw-priority 0 GKTrunk_1 GKTrunk_2 zone prefix HQ-RTR1 212* gw-priority 10 GKTrunk_2 zone prefix HQ-RTR1 30* gw-priority 10 CME zone prefix HQ-RTR1 30* gw-priority 0 GKTrunk_1 GKTrunk_2 zone prefix HQ-RTR1 617* gw-priority 10 GKTrunk_2 no shutdown ! ========================================================== HQ#sh gatekeeper end GATEKEEPER ENDPOINT REGISTRATION ================================ CallSignalAddr Port RASSignalAddr Port Zone Name Type Flags --------------- ----- --------------- ----- --------- ---- ----- 10.1.200.20 1720 10.1.200.20 1719 HQ-RTR1 VOIP-GW H323-ID: GKTrunk_1 Voice Capacity Max.= Avail.= Current.= 0 10.1.200.21 1720 10.1.200.21 1719 HQ-RTR1 VOIP-GW H323-ID: GKTrunk_2 Voice Capacity Max.= Avail.= Current.= 0 172.1.102.1 1720 172.1.102.1 55998 HQ-RTR1 VOIP-GW H323-ID: CME Voice Capacity Max.= Avail.= Current.= 0 Total number of active registrations = 3 BR2#sh gatewa H.323 ITU-T Version: 4.0 H323 Stack Version: 0.1 H.323 service is up Gateway CME is registered to Gatekeeper HQ-RTR1 Alias list (CLI configured) H323-ID CME Alias list (last RCF) H323-ID CME H323 resource thresholding is Disabled ========================================================== BR2: ========================================================== BR2#sh run | begin oopb interface Loopback0 ip address 172.1.102.1 255.255.255.255 ip ospf network point-to-point h323-gateway voip interface h323-gateway voip id HQ-RTR1 multicast h323-gateway voip h323-id CME h323-gateway voip tech-prefix 1# ! ========================================================== BR2#sh gatew H.323 ITU-T Version: 4.0 H323 Stack Version: 0.1 H.323 service is up Gateway CME is registered to Gatekeeper HQ-RTR1 Alias list (CLI configured) H323-ID CME Alias list (last RCF) H323-ID CME H323 resource thresholding is Disabled ========================================================== Greg Jost Network Consulting Engineer Unified Communications Practice Cisco Systems, Inc. 214-274-1922 ________________________________ From: Edward French [mailto:[EMAIL PROTECTED] Sent: Friday, April 18, 2008 9:57 PM To: Gregory Jost (grjost); CCIE Maillist Subject: Re: [OSL | CCIE_Voice] Weird Gatekeeper Issue I no longer have access to the equipment so i had to recreate it as bes as I could ----- Original Message ---- From: Gregory Jost (grjost) <[EMAIL PROTECTED]> To: Edward French <[EMAIL PROTECTED]>; CCIE Maillist <ccie_voice@onlinestudylist.com> Sent: Friday, April 18, 2008 8:08:09 PM Subject: Re: [OSL | CCIE_Voice] Weird Gatekeeper Issue There’s several typos in there. Can you copy in the actual config instead of typing it? Greg Jost Network Consulting Engineer Unified Communications Practice Cisco Systems, Inc. 214-274-1922 ________________________________ From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Edward French Sent: Friday, April 18, 2008 6:23 PM To: CCIE Maillist Subject: [OSL | CCIE_Voice] Weird Gatekeeper Issue HQ Configured as a gatekeeper as follows Zone Local CCM ipexpert.com 172.21.100.1 zone local Branch2 ipexpet.com zone prefix CCM 1... zone prefix CCM 2... zone Prefix Branch2 3... Branch 2 configured as Int f0/0.210 ip add 10.21.202.1 255.255.255.0 h323-g v int h323-g v id Branch2 ip 172.21.100.1 h323-g v h323-id cme-gw h323-g v bind sour 10.21.201.1 The registration gets redirected but if I change the Zone from Branch2 to CME it registers, In fact I tried several different zones but only CME or CCM would work any Ideas? By the way this was on 3725's Ed