Hi Abdallah Yes, the gateway is registered. I am able to get incoming calls to HQ phone.
Enable Status Poll is checked. I am using IP Blue for PSTN phone. What about B Channel Maintenance Status 2, 3, 4, and 5 (under CM service parameter), Do I need to fill them in? AH --- On Fri, 6/6/08, Abdalla Abdalla <[EMAIL PROTECTED]> wrote: > From: Abdalla Abdalla <[EMAIL PROTECTED]> > Subject: Re: [OSL | CCIE_Voice] Outgoing Calls on Cat 6608 PIR Gateway > To: [EMAIL PROTECTED] > Date: Friday, June 6, 2008, 7:40 PM > Check that the gateway is registered. If you are using a > route list check that it is also registered. > Did you check enable status poll under the gateway? > > > ----- Original Message ---- > From: Ahmed Hamed <[EMAIL PROTECTED]> > To: [EMAIL PROTECTED] > Cc: ccievoice <ccie_voice@onlinestudylist.com> > Sent: Friday, June 6, 2008 8:35:54 PM > Subject: [OSL | CCIE_Voice] Outgoing Calls on Cat 6608 PIR > Gateway > > > > > > Hi Abdalla, > > > > Yes, I am using bottom up. > > > > and > > > > Change B-Channel Maintenance Status 1: > > S0/[EMAIL PROTECTED] > > > > Please advise, > > > > AH > > > > > > > > --- On Fri, 6/6/08, Abdalla Abdalla > > <[EMAIL PROTECTED]> wrote: > > > > From: Abdalla Abdalla > <[EMAIL PROTECTED]> > > Subject: Re: [OSL | CCIE_Voice] Outgoing Calls on Cat > 6608 > > PIR Gateway > > To: [EMAIL PROTECTED] > > Date: Friday, June 6, 2008, 7:25 PM > > > > > > > > > > > > > > Are you using bottom up isdn channel selection? > > If so you need to configure the service parameter and > busy > > out the isdn bchannels. > > > > regards > > > > abdalla > > > > > > ----- Original Message ---- > > From: Ahmed Hamed <[EMAIL PROTECTED]> > > To: ccievoice <ccie_voice@onlinestudylist.com> > > Sent: Friday, June 6, 2008 8:15:30 PM > > Subject: [OSL | CCIE_Voice] Outgoing Calls on Cat 6608 > PIR > > Gateway > > > > > > > > > > > > > > > > Hi, > > > > I am trying to test outgoing calls from HQ phone to > PSTN > > phone through 6608 Digital PRI gateway.. > > > > I am able to have incoming calls to HQ phone BUT > outgoing > > calls (opposite) are failing.. > > I am getting busy tone.. > > > > Any idea? > > > > Please advise, > > > > AH