It sounds like unity is not registering its ports with the callmanager. On the Unity server, go into the Telephony Integration under system tools and test your integration. If that fails make sure the port names in unity match what you have set on callmanager. Try restarting Unity too.

jeremy co wrote:
Hi,

Jacob I did the firs two. but I'm not sure what u mean by registering vm ports.

on unity I can verify ,call manager integration, and on ccm on "voice mail ports",I can see "not found" status.

When I hit message button, I hear fast busy tone.

When I dial pilot number ,also hear fast busy signal. I think CCM not forward call to unity

btw, every thing is in none partition, no CSS.



Jeremy


On Thu, Oct 30, 2008 at 5:12 AM, Chris Parker <[EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]>> wrote:

    What happens when you dial you voicemail pilot? Does the call ring
    through? Are phones able to access voicemail via the messages key?

    If the answers to the above are yes, then I would look at possible
    codec or CAC problems. For example is the call rinnging into the
    phone 729, then trying to go 711 when it goes to Unity? If so you
    may need to check your transcoder.


    jeremy co wrote:

        Hi,


        I integrate CCM to unity and define 4 ports on both unity and
        ccm.Then, check DN's options on Phones to forward unanswered
        calls to voice mail. Subscribers are created with extention of
        3001 and 3007 and set active schedule to "all houres- alldays"

        I have 2 IPphones with DN's of 3001 and 3007.

        When I call another ip phone and one does not answer the call,
        I hear fast busy tone and nothing is forwarded to voice mail.

        Am I miss anything?

        Jeremy




Reply via email to