are we talking 539s or 5510 dsps?  read somewhere that 5510 dsps can be
oversubscribed.  that is, since oversubscribed may be mistaken as term
loosely used in this case, the 5510 dsp can be allocated to dspfarm and
be used for the voice-port.  so when it is not being used to encode PCM
to g711/g729/etc on the voice-port it is available for transcoding or
conference bridge.  i believe 539 only have 4 channels and 5510 have 6
channels.  let me do a sh voice dsp or sh dspfarm dsp all to verify
before anybody takes my word for it!>:0o Norm

  ----- Original Message -----
  From: "Kevin Porter"
  To: [email protected]
  Subject: [OSL | CCIE_Voice] CME Transcoder units and sessions
  Date: Thu, 30 Oct 2008 09:58:55 -0500

Question on CME Transcoder values…

Is the “sdspfarm units <1-5>” referring to the number of “voice-card”
interfaces that would be used for transcoding?

What is the calculation used to determine how many sessions you can
configure for “extra” DSP channels…Say you have three PVDM-12’s and a
four channel PRI in the router…I think I recall hearing from one of the
bootcamps that the Transcoder uses two channels per session?  If so,
would the calculation be…36 channels total minus four for the PRI,
leaving 32 and divide by two, resulting in 16 sessions?

Thanks,

Kevin

Kevin Porter
Systems Engineer L4

Netelligent Corporation
400 South Woods Mill Drive, Suite 105
St. Louis, MO 63017

Office: (314) 392-6921
Cell: (314) 852-1252
Fax: (314) 392-9760

[EMAIL PROTECTED]
www.netelligent.com
Bridging The Gap Between Good and GREAT IP Communications!

-- 
Be Yourself @ mail.com!
Choose From 200+ Email Addresses
Get a Free Account at www.mail.com

Reply via email to