I'm running auto qos for the WAN for a 384K link using MLPP. The auto qos presents the following configuration policy-map AutoQoS-Policy-Trust class AutoQoS-VoIP-RTP-Trust priority percent 70 class AutoQoS-VoIP-Control-Trust no band bandwidth percent 5 class class-default fair-queue
interface Serial0/0/0:0.1 point-to-point bandwidth 384 ip ospf mtu-ignore frame-relay interface-dlci 201 ppp Virtual-Template200 class AutoQoS-FR-Se0/0/0:0-201 auto qos voip trust fr-atm interface Virtual-Template200 bandwidth 384 ip address 162.2.101.1 255.255.255.0 ppp multilink ppp multilink fragment delay 10 ppp multilink interleave service-policy output AutoQoS-Policy-Trust map-class frame-relay AutoQoS-FR-Se0/0/0:0-201 frame-relay cir 384000 frame-relay bc 3840 frame-relay be 0 frame-relay mincir 384000 The problem is in trying to verify it. I run the following but get no output sh policy-map int Serial0/0/0:0.1 No change has been made to the configuration after the auto qos. Can you not verify with this command using MLPP? Von Clawson Sr. Voice Engineer Nexus IS Technical Assistance Center Nexus IS, Inc. Office: 480.517.6672 Mobile: 480.200.1918 Fax: 480.517.6673 von.claw...@nexusis.com<mailto:von.claw...@nexusis.com> www.nexusis.com<http://www.nexusis.com/> [cid:image001.gif@01C9E6B7.08F11230][cid:image002....@01c9e6b7.08f11230] The information contained in this email and any additional attachments is confidential and may be legally privileged. If you are not the intended recipient then you must not use, disseminate, distribute or copy any information contained in this email or any attachments. If you receive this email in error, please destroy it immediately and contact us . Thank you.
<<inline: image001.gif>>
<<inline: image002.jpg>>