Update ,
unhold/hold is not working when MRGL { MRG {MOH (Multicast)} , MRG {SW MTP}
}
hold/unhold is working when MRGL {MRG {SW MTP} }
Could anybody direct me what the heck happen here ? What's MMOH has to do
woth using MTP or not in MRGL ?
Really been crazy on this.
Jeremy
On Sat, Jun 27, 2009 at 11:54 PM, jeremy co <[email protected]> wrote:
> Update ,
>
> from Perfmon SW MTP invoked but after making call nad hold/unhold and,
> call get disconnected, perfmon shows it wouldn't release MTP resource!!!!
>
>
> What's wrong here ?
>
>
>
> On Sat, Jun 27, 2009 at 11:48 PM, jeremy co <[email protected]>wrote:
>
>> I configured it 10 times but it's not working now.
>>
>>
>> for isolating problem. MRG ---> MTP SW , DP,G711,MRGL ---> Trunk SIP
>>
>> dial-peer voice 1000 voip
>> session protocol sipv2
>> incoming called-number .
>> dtmf-relay sip-notify rtp-nte
>> codec g711ulaw
>> no vad
>> !
>> dial-peer voice 1002 pots
>> destination-pattern 2122
>> port 2/1
>> forward-digits all
>> !
>> dial-peer voice 4002 voip
>> destination-pattern 2...
>> session protocol sipv2
>> session target ipv4:142.4.64.11
>> dtmf-relay sip-notify rtp-nte
>> codec g711ulaw
>> no vad
>> !
>> dial-peer voice 4003 voip
>> destination-pattern 3...
>> session protocol sipv2
>> session target ipv4:142.4.64.11
>> dtmf-relay sip-notify rtp-nte
>> codec g711ulaw
>> no vad
>> !
>>
>> HQro FXS calling When I put it on hold ,I couldn't unhold it anymore. MTP
>> wouldn't invoke.
>>
>> Anybody faced this before?
>>
>
>
