as per my understanding that you have problem fron br2 to cucm , and your trunk is set to g711 do you have an active transcoder at hq router ?
On Sat, Aug 28, 2010 at 3:21 AM, <dcrayto...@comcast.net> wrote: > > Hello guys, > > I am struggling with a gatekeeper scenario. > > Basically, the lab calls for HQ, BR1, and BR2 to use a GK to route internal > calls via 4 digits. > > Of course BR2 is a CUCME. > > I can succesfully place calls from the CUCM registered phones, but not from > CUCME to CUCM registered phones. > > I am sure that CUCM is giving the incorrect number dialed message, but I > cannot pinpoint why. > > My config is as follows: > > HQ Gatekeeper > > voice service voip > allow-connections h323 to h323 > allow-connections h323 to sip > allow-connections sip to h323 > allow-connections sip to sip > fax protocol cisco > h323 > sip > bind control source-interface Loopback0 > bind media source-interface Loopback0 > > interface Loopback0 > ip address 10.10.1.1 255.255.255.255 > h323-gateway voip interface > h323-gateway voip bind srcaddr 10.10.1.1 > > gatekeeper > zone local PL cisco.com > zone prefix PL 1... gw-priority 10 gk-trunk_2 > zone prefix PL 1... gw-priority 9 gk-trunk_1 > zone prefix PL 1... gw-priority 0 SiteC > zone prefix PL 3* gw-priority 10 SiteC > zone prefix PL 3* gw-priority 0 gk-trunk_2 gk-trunk_1 > zone prefix PL 5... gw-priority 10 gk-trunk_2 > zone prefix PL 5... gw-priority 9 gk-trunk_1 > zone prefix PL 5... gw-priority 0 SiteC > no shutdown > > BR2 CUCME > voice service voip > allow-connections h323 to h323 > allow-connections h323 to sip > allow-connections sip to h323 > allow-connections sip to sip > fax protocol cisco > h323 > h225 listen-port 1820 > no call service stop > sip > bind control source-interface Loopback0 > bind media source-interface Loopback0 > registrar server expires max 600 min 60 > > > interface Loopback0 > ip address 10.10.3.1 255.255.255.255 > h323-gateway voip interface > h323-gateway voip id PL ipaddr 10.10.1.1 1719 > h323-gateway voip h323-id SiteC > h323-gateway voip tech-prefix 3 > h323-gateway voip bind srcaddr 10.10.3.1 > > dial-peer voice 1000 voip > destination-pattern [15]... > session target ras > tech-prefix 1# > dtmf-relay h245-alphanumeric > codec g711ulaw > ip qos dscp cs3 signaling > no vad > > > Sucessful call from HQ/BR1 to BR2 site > > From ext 1004 to 3001 via gatekeeper > > *Aug 27 21:18:17.167: //xxxxxxxxxxxx/xxxxxxxxxxxx/GK/gk_process: > QUEUE_EVENT (minor 0) wakeup > *Aug 27 21:18:17.167: //xxxxxxxxxxxx/xxxxxxxxxxxx/GK/gk_rassrv_arq: > arqp=0x487106CC,crv=0x1, answerCall=0 > *Aug 27 21:18:17.167: //xxxxxxxxxxxx/xxxxxxxxxxxx/GK/gk_rassrv_sep_arq: ARQ > Didn't use GK_AAA_PROC > *Aug 27 21:18:17.167: //004AB3920100/004AB3920100/GK/gk_dns_query: No Name > servers > *Aug 27 21:18:17.167: //004AB3920100/004AB3920100/GK/rassrv_get_addrinfo: > (3001) Matched tech-prefix 3 > *Aug 27 21:18:17.167: //004AB3920100/004AB3920100/GK/rassrv_get_addrinfo: > (3001) unresolved zone prefix, using source zone PL > *Aug 27 21:18:17.167: > //xxxxxxxxxxxx/xxxxxxxxxxxx/GK/gk_rassrv_get_ingress_network: returning > default ingress network = 1 > *Aug 27 21:18:17.167: > //004AB3920100/004AB3920100/GK/rassrv_arq_select_viazone: about to check the > source side, src_zonep=0x4877E344 > *Aug 27 21:18:17.167: > //004AB3920100/004AB3920100/GK/rassrv_arq_select_viazone: matched zone is > PL, and z_invianamelen=0 > *Aug 27 21:18:17.167: > //004AB3920100/004AB3920100/GK/rassrv_arq_select_viazone: about to check the > destination side, dst_zonep=0x4877E344 > *Aug 27 21:18:17.167: > //004AB3920100/004AB3920100/GK/rassrv_arq_select_viazone: matched zone is > PL, and z_outvianamelen=0 > *Aug 27 21:18:17.167: > //xxxxxxxxxxxx/xxxxxxxxxxxx/GK/gk_rassrv_get_ingress_network: returning > default ingress network = 1 > *Aug 27 21:18:17.199: //xxxxxxxxxxxx/xxxxxxxxxxxx/GK/gk_process: > QUEUE_EVENT (minor 0) wakeup > *Aug 27 21:18:17.199: //xxxxxxxxxxxx/xxxxxxxxxxxx/GK/gk_rassrv_arq: > arqp=0x48856C9C,crv=0x1B, answerCall=1 > *Aug 27 21:18:17.199: //004AB3920100/004AB3920100/GK/gk_rassrv_dep_arq: ARQ > Didn't use GK_AAA_PROC > *Aug 27 21:18:26.799: //xxxxxxxxxxxx/xxxxxxxxxxxx/GK/gk_process: > QUEUE_EVENT (minor 0) wakeup > *Aug 27 21:18:26.807: //xxxxxxxxxxxx/xxxxxxxxxxxx/GK/gk_process: > QUEUE_EVENT (minor 0) wakeup > *Aug 27 21:18:31.015: //xxxxxxxxxxxx/xxxxxxxxxxxx/GK/gk_process: got a > TIMER event > > > > Failed Call from BR2 to UCM > > From CUCME 1004 to HQ 5001 > > *Aug 27 21:44:12.055: //xxxxxxxxxxxx/xxxxxxxxxxxx/GK/gk_process: > QUEUE_EVENT (minor 0) wakeup > *Aug 27 21:44:12.055: //xxxxxxxxxxxx/xxxxxxxxxxxx/GK/gk_rassrv_arq: > arqp=0x47EE1530,crv=0x1C, answerCall=0 > *Aug 27 21:44:12.055: //xxxxxxxxxxxx/xxxxxxxxxxxx/GK/gk_rassrv_sep_arq: ARQ > Didn't use GK_AAA_PROC > *Aug 27 21:44:12.055: //B6D0B3BB80B3/B6D14FE380B5/GK/gk_dns_query: No Name > servers > *Aug 27 21:44:12.055: //B6D0B3BB80B3/B6D14FE380B5/GK/rassrv_get_addrinfo: > (1#5001) Matched tech-prefix 1# > *Aug 27 21:44:12.055: //B6D0B3BB80B3/B6D14FE380B5/GK/rassrv_get_addrinfo: > (1#5001) Matched zone prefix 5 and remainder 001 > *Aug 27 21:44:12.055: > //xxxxxxxxxxxx/xxxxxxxxxxxx/GK/gk_rassrv_get_ingress_network: ARQ non-std > ingress network = 1 > *Aug 27 21:44:12.055: > //B6D0B3BB80B3/B6D14FE380B5/GK/rassrv_arq_select_viazone: about to check the > source side, src_zonep=0x4877E344 > *Aug 27 21:44:12.055: > //B6D0B3BB80B3/B6D14FE380B5/GK/rassrv_arq_select_viazone: matched zone is > PL, and z_invianamelen=0 > *Aug 27 21:44:12.055: > //B6D0B3BB80B3/B6D14FE380B5/GK/rassrv_arq_select_viazone: about to check the > destination side, dst_zonep=0x4877E344 > *Aug 27 21:44:12.055: > //B6D0B3BB80B3/B6D14FE380B5/GK/rassrv_arq_select_viazone: matched zone is > PL, and z_outvianamelen=0 > *Aug 27 21:44:12.055: > //xxxxxxxxxxxx/xxxxxxxxxxxx/GK/gk_rassrv_get_ingress_network: ARQ non-std > ingress network = 1 > *Aug 27 21:44:14.467: //xxxxxxxxxxxx/xxxxxxxxxxxx/GK/gk_process: > QUEUE_EVENT (minor 0) wakeup > *Aug 27 21:44:17.267: //xxxxxxxxxxxx/xxxxxxxxxxxx/GK/gk_process: got a > TIMER event > > > > > > My CUCM trunk has the proper css and access to the dn partition. > > The trunk is in a g711 device pool that mandates codec g711. > > Also, I have routed the call using the "4" sig digits on the incoming leg > and by using a translation pattern that strips the tech prefix of 1#. > > Any help would be appreciated. > > Thanks > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
