Also check that the interface of the ip address you used to add the gateway in CUCM has the h323-gateway voip bind srcaddr to be sure that h323 is sourced from that IP otherwise CUCM will reject the call unless connection from unknow source is allowed in service parameters. Please send the other debugs mentioned by Roger Kallberg
On 12 March 2011 19:31, Support <supp...@technisha.com> wrote: > Dear Rogers, > > > > I changed as you suggested , but same issue, I cannot hear ring on IP > Phone. > > > > R3#test voice translation-rule 5 24044002 > > Matched with rule 1 > > Original number: 24044002 Translated number: 4002 > > Original number type: none Translated number type: none > > Original number plan: none Translated number plan: none > > > > ! > > dial-peer voice 5 pots > > incoming called-number . > > direct-inward-dial > > > > but same behavior , > > > > > > > > R3#sh dialplan number 4002 > > Macro Exp.: 4002 > > > > VoiceOverIpPeer11 > > peer type = voice, system default peer = FALSE, information type = > voice > > , > > description = `', > > tag = 11, destination-pattern = `4...$', > > voice reg type = 0, corresponding tag = 0, > > allow watch = FALSE > > answer-address = `', preference=1, > > CLID Restriction = None > > CLID Network Number = `' > > CLID Second Number sent > > CLID Override RDNIS = disabled, > > source carrier-id = `', target carrier-id = `', > > source trunk-group-label = `', target trunk-group-label = `', > > numbering Type = `unknown' > > group = 11, Admin state is up, Operation state is up, > > incoming called-number = `', connections/maximum = 0/unlimited, > > DTMF Relay = enabled, > > modem transport = system, > > URI classes: > > Incoming (Called) = > > Incoming (Calling) = > > Destination = > > huntstop = disabled, > > in bound application associated: 'DEFAULT' > > out bound application associated: '' > > dnis-map = > > permission :both > > incoming COR list:maximum capability > > outgoing COR list:minimum requirement > > Translation profile (Incoming): > > Translation profile (Outgoing): > > incoming call blocking: > > translation-profile = `' > > disconnect-cause = `no-service' > > advertise 0x40 capacity_update_timer 25 addrFamily 4 oldAddrFamily > 4 > > type = voip, session-target = `ipv4:142.100.64.11', > > technology prefix: > > settle-call = disabled > > ip media DSCP = ef, ip signaling DSCP = af31, > > ip video rsvp-none DSCP = af41,ip video rsvp-pass DSCP = af41 > > ip video rsvp-fail DSCP = af41, > > UDP checksum = disabled, > > session-protocol = cisco, session-transport = system, > > req-qos = best-effort, acc-qos = best-effort, > > req-qos video = best-effort, acc-qos video = best-effort, > > req-qos audio def bandwidth = 64, req-qos audio max bandwidth = 0, > > req-qos video def bandwidth = 384, req-qos video max bandwidth = 0, > > dtmf-relay = h245-alphanumeric, > > RTP dynamic payload type values: NTE = 101 > > Cisco: NSE=100, fax=96, fax-ack=97, dtmf=121, fax-relay=122 > > CAS=123, TTY=119, ClearChan=125, PCM switch over u-law=0, > > A-law=8, GSMAMR-NB=117 iLBC=116 > > h263+=118, h264=119 > > G726r16 using static payload > > G726r24 using static payload > > RTP comfort noise payload type = 19 > > fax rate = voice, payload size = 20 bytes > > fax protocol = system > > fax-relay ecm enable > > Fax Relay SG3-to-G3 Enabled (by system configuration) > > fax NSF = 0xAD0051 (default) > > voice-class codec = 1 > > codec = g729r8, payload size = 20 bytes, > > video codec = None > > voice class codec = 1 > > text relay = disabled > > Media Setting = flow-through (global) > > Expect factor = 10, Icpif = 20, > > Playout Mode is set to adaptive, > > Initial 60 ms, Max 250 ms > > Playout-delay Minimum mode is set to default, value 40 ms > > Fax nominal 300 ms > > Max Redirects = 1, signaling-type = cas, > > VAD = disabled, Poor QOV Trap = disabled, > > Source Interface = NONE > > voice class sip url = system, > > voice class sip rel1xx = system, > > tvoice class sip outbound-proxy = system, > > voice class sip asserted-id = system, > > voice class sip privacy = system, > > voice class sip e911 = system, > > voice class sip authenticate redirecting-number = system, > > redirect ip2ip = disabled > > local peer = false > > probe disabled, > > Secure RTP: system (use the global setting) > > voice class perm tag = `' > > Time elapsed since last clearing of voice call statistics never > > Connect Time = 0, Charged Units = 0, > > Successful Calls = 0, Failed Calls = 6, Incomplete Calls = 0 > > Accepted Calls = 0, Refused Calls = 0, > > Last Disconnect Cause is "26 ", > > Last Disconnect Text is "network out of order (38)", > > Last Setup Time = 10571678. > > Last Disconnect Time = 0. > > Matched: 4002 Digits: 2 > > Target: ipv4:142.100.64.11 > > > > R3#ping 142.100.64.11 > > > > Type escape sequence to abort. > > Sending 5, 100-byte ICMP Echos to 142.100.64.11, timeout is 2 seconds: > > !!!!! > > Success rate is 80 percent (4/5), round-trip min/avg/max = 1/1/1 ms > > R3# > > > __________ Information from ESET NOD32 Antivirus, version of virus > signature database 5946 (20110311) __________ > > The message was checked by ESET NOD32 Antivirus. > > http://www.eset.com >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
