What is the codec between regions? Make sure you're using g729 and disable the g722 advertising and also the iLBC
From: ccie_voice-boun...@onlinestudylist.com [mailto:ccie_voice-boun...@onlinestudylist.com] On Behalf Of Vinay Kumar6 Sent: Friday, April 29, 2011 11:28 AM Cc: ccie_voice@onlinestudylist.com; ccie_voice-boun...@onlinestudylist.com Subject: Re: [OSL | CCIE_Voice] RSVP based CAC Following is the config on the routers. interface Serial0/0/0.1 point-to-point ip address 10.10.1.1 255.255.255.0 ip ospf mtu-ignore snmp trap link-status frame-relay interface-dlci 401 ip rsvp bandwidth 40 dspfarm profile 2 mtp codec g729r8 codec pass-through rsvp maximum sessions software 4 associate application SCCP dspfarm profile 1 mtp codec g729r8 codec pass-through rsvp maximum sessions software 4 associate application SCCP interface Serial0/2/0.1 point-to-point ip address 10.10.1.2 255.255.255.0 ip ospf mtu-ignore snmp trap link-status frame-relay interface-dlci 501 ip rsvp bandwidth 40 Is there any step by step guide to configure or troubleshoot it? Warm Regards, Vinay Kumar From: Vinay Kumar6/India/IBM@IBMIN To: Rogers Ochieng <rogersochi...@gmail.com> Cc: ccie_voice@onlinestudylist.com Date: 04/29/2011 11:46 AM Subject: Re: [OSL | CCIE_Voice] RSVP based CAC ________________________________ Yes, it is there. Warm Regards, Vinay Kumar From: Rogers Ochieng <rogersochi...@gmail.com> To: Vinay Kumar6/India/IBM@IBMIN Cc: ccie_voice@onlinestudylist.com Date: 04/29/2011 10:25 AM Subject: Re: [OSL | CCIE_Voice] RSVP based CAC ________________________________ do you have this under your IOS dspfarm profile Mtp configuration rsvp codec pass-through On 29 April 2011 07:24, Vinay Kumar6 <vinayjaisw...@in.ibm.com<mailto:vinayjaisw...@in.ibm.com>> wrote: Hi, Trying to configure Location based CAC using RSVP, have done the configuration buut it always says not enough bandwidth even though i have given ample bandwidth on the serial interfaces. Steps used to configure: Configured MTP on the HQ and Branches-Registered to HQ and Branch DP. Assigned the HQ and Branch MTPs to respective DPs using MRGL. Created Location for HQ and Branch and assigned to respective DPs. Reservation is mandatory. Codec used on between the regions is G729. Warm Regards, Vinay Kumar _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com<http://www.ipexpert.com/> Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com<http://www.platinumplacement.com/> _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com ********************************************************************************************************************************************************************************************************************* * This Communication is Private & Confidential. This message and any attachments may contain information that is privileged and / or confidential and is the property of MHD InfoTech LLC. * * It is intended solely for the person to whom it is addressed. If you are not the intended recipient, you are hereby notified that you are not authorized to read, print, retain copy, disseminate, distribute, or * * use this message & any attachments or any part thereof. If you have received this message in error, please notify the sender immediately and delete the message and any attachments from your system. * *********************************************************************************************************************************************************************************************************************
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com