Remove the bind commands and let it register then you can put them back in On May 17, 2011 1:03 AM, "Hough, Earl" <earl.ho...@pcmallservices.com> wrote: > Randall, > > Dumb question, but is your Loopback0 have an IP address and not shutdown? Also, if you source a ping from the loopback0, is it able to get to the UCM servers? > > If you source the MGCP media and control packets from another interface does it register? > > Does the output of "debug mgcp packet" show anything trying to be sent toward the UCM? > > Also, have you tried going back to a plain vanilla Serial0/0/0:23 configuration that only has the bare minimum of statements? > > Earl Hough > CCIE #16508 (R&S/Security/Voice) > > From: ccie_voice-boun...@onlinestudylist.com [mailto: ccie_voice-boun...@onlinestudylist.com] On Behalf Of Chevy > Sent: Monday, May 16, 2011 4:53 PM > To: Randall Crumm > Cc: ccie_voice@onlinestudylist.com > Subject: Re: [OSL | CCIE_Voice] MGCP GW will not register in CM -- Unknown > > > Did you verify that the model of the gateway and the vwic in the gateway are correct in UCM > > Thanks, > > Chevy > On May 16, 2011 3:48 PM, "Randall Crumm" <randall.cr...@flextronics.com <mailto:randall.cr...@flextronics.com>> wrote: >> HI, >> >> Having an issue in Call Manager. My br1 config looks good just can't get >> it to register in call manager. >> >> >> >> Any ideas? I've reloaded the router, deleted the GW and recreated it. No >> mgcp and mgcp. Etc... >> >> >> >> Here are snipit of the config and CUCM page >> >> >> >> BR1-RTR(config)#do show ccm >> >> MGCP Domain Name: BR1-RTR.proctorlabs.com<http://BR1-RTR.proctorlabs.com> >> >> Priority Status Host >> >> ============================================================ >> >> Primary Registered 10.10.210.11 >> >> First Backup Backup Ready 10.10.210.10 >> >> Second Backup None >> >> >> >> Current active Call Manager: 10.10.210.11 >> >> Backhaul/Redundant link port: 2428 >> >> Failover Interval: 30 seconds >> >> Keepalive Interval: 15 seconds >> >> Last keepalive sent: 11:48:05 EST May 14 2011 (elapsed time: >> 00:00:07) >> >> Last MGCP traffic time: 11:48:05 EST May 14 2011 (elapsed time: >> 00:00:07) >> >> Last failover time: 11:11:05 EST May 14 2011 from >> (10.10.210.11) >> >> Last switchback time: 11:11:35 EST May 14 2011 from >> (10.10.210.10) >> >> Switchback mode: Immediate >> >> MGCP Fallback mode: Not Selected >> >> Last MGCP Fallback start time: None >> >> Last MGCP Fallback end time: None >> >> MGCP Download Tones: Disabled >> >> TFTP retry count to shut Ports: 2 >> >> >> >> Backhaul Link info: >> >> Link Protocol: TCP >> >> Remote Port Number: 2428 >> >> Remote IP Address: 10.10.210.11 >> >> Current Link State: OPEN >> >> Statistics: >> >> Packets recvd: 3 >> >> Recv failures: 2 >> >> Packets xmitted: 1 >> >> Xmit failures: 0 >> >> PRI Ports being backhauled: >> >> Slot 0, VIC 0, port 0 >> >> FAX mode: cisco >> >> Configuration Error History: >> >> BR1-RTR(config)# >> >> >> >> >> >> >> >> ccm-manager switchback immediate >> >> ccm-manager redundant-host 10.10.210.10 >> >> ccm-manager mgcp >> >> ! >> >> mgcp >> >> mgcp call-agent 10.10.210.11 service-type mgcp version 0.1 >> >> mgcp dtmf-relay voip codec all mode out-of-band >> >> mgcp bind control source-interface Loopback0 >> >> mgcp bind media source-interface Loopback0 >> >> ! >> >> >> >> interface Serial0/0/0:23 >> >> no ip address >> >> encapsulation hdlc >> >> isdn switch-type primary-ni >> >> isdn incoming-voice voice >> >> isdn map address ^[2-9]...... plan isdn type subscriber >> >> isdn map address ^1[2-9]* plan isdn type national >> >> isdn map address ^011* plan isdn type international >> >> isdn bind-l3 ccm-manager >> >> isdn bchan-number-order ascending >> >> isdn outgoing display-ie >> >> no cdp enable >> >> >> >> >> >> CUCM... >> >> Device InformationProduct Cisco MGCP T1 Port >> >> Gateway BR1-RTR.proctorlabs.com<http://BR1-RTR.proctorlabs.com> >> >> Device Protocol Digital Access PRI >> >> Registration Unknown >> >> IP Address Unknown >> >> End-Point Name S0/SU0/ds...@br1-rtr.proctorlabs.com<mailto: ds...@br1-rtr.proctorlabs.com> >> >> >> >> Best Regards, >> >> >> >> Randall Crumm >> >> Voice and Video Architect >> >> Global Networking & Telecom >> >> >> >> >> >> >> >> >> >> 1007 Gibraltar Drive >> >> Milpitas, CA 95035 >> >> >> >> Direct +1 408.576.7344 >> >> VoIP 6666.100.7344 >> >> >> >> >> >> Creating value that increases >> >> customer competitiveness >> >> >> >> >> >> Legal Disclaimer: >> The information contained in this message may be privileged and confidential. It is intended to be read only by the individual or entity to whom it is addressed or by their designee. If the reader of this message is not the intended recipient, you are on notice that any distribution of this message, in any form, is strictly prohibited. If you have received this message in error, please immediately notify the sender and delete or destroy any copy of this message >> > _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ > > The information contained in this transmission is confidential. It is > intended solely for the use of the individual(s) or organization(s) to > whom it is addressed. Any disclosure, copying or further distribution is > not permitted unless such privilege is explicitly granted in writing by > PC Mall, Inc. Furthermore, PC Mall, Inc. is not responsible for > the proper and complete transmission of the substance of this > communication, nor for any delay in its receipt. >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
