Adil;
For testing, create a G711-region only device pool and put your H323 gw in
that DP. So all devices even PSTN should be able to make the call.
If not than, there might be some other config error.
Start from there to see where it's failing. I got through testing yesterday
but reset my rack.
As suggested earlier make sure you don't user voice class codec in your
Dialpeer.
Also, your config is interesting, have to try it next time.
But since a "known good" config (in this forum for Lab takers) is to make
the Route Parttern number the same as the MVA number, you could try that,
again just to see that it all works, and there isn't some other issue.
Sam.
On Wed, Jun 15, 2011 at 9:02 AM, Adil Shaikh <adil.sha...@gmail.com> wrote:
> Hi SinGei,
>
> I do not have translation pattern in CM. You call flow is aboslutely
> correct. Just for clarity. I am adding few things in your call flow as
> below:
>
> PSTN IN [4158881999]--> mgcp gw [4digit]--> route pattern[1999] --> h323 gw
> --> match incoming [1999] (service mva configure) dp {here service mva
> URL talks to publisher and downloads the MVA number configured in CM - in
> my case it is 1998}-->match outgoing mva# dp [1998] --> UCM
> I hope this clarifies the setup.
>
> -adil
>
> On Wed, Jun 15, 2011 at 9:49 PM, ShinGei Yong <shingei.y...@gmail.com>wrote:
>
>> hi Adil,
>>
>> Apologize for the questions, because never try your setup before.
>>
>> How do you translate the mgcp incoming 1999 to 1998? Do you have any
>> translation?
>> If not, how are you going to match the DNIS#
>>
>> My understanding was:
>>
>> PSTN IN --> mgcp gw --> route pattern --> h323 gw --> match incoming mva#
>> (service mva configure) dp-->match outgoing mva# dp --> UCM
>>
>> TIA
>> Shingei
>>
>>
>> On Wed, Jun 15, 2011 at 7:32 PM, Adil Shaikh <adil.sha...@gmail.com>wrote:
>>
>>> hi ShinGei,
>>>
>>> The MVA number is 1998.
>>> Rather than using same number for the inbound to application service mva
>>> and outbound to MVA number, two seperate numbers are used.
>>>
>>> So, inbound dialpeer to application service mva is 1999 and after
>>> hairpinning on Gateway the outbound number is 1998 which is the Mobile Voice
>>> Access number configured on the Call Manager.
>>>
>>> i hope this clarifies what i am trying to do.
>>>
>>> thanks
>>> -adil
>>>
>>> On Wed, Jun 15, 2011 at 9:27 PM, ShinGei Yong <shingei.y...@gmail.com>wrote:
>>>
>>>> Hi,
>>>>
>>>> May i know where is your outbound dp for mva#1999?
>>>> What is the purpose of 1998 ?
>>>>
>>>> TIA
>>>> Shingei
>>>>
>>>>
>>>> On Wed, Jun 15, 2011 at 2:26 PM, Adil Shaikh <adil.sha...@gmail.com>wrote:
>>>>
>>>>> Forgot to add that HQ and BR1 phones are sccp.
>>>>>
>>>>>
>>>>> On Wed, Jun 15, 2011 at 4:21 PM, Adil Shaikh <adil.sha...@gmail.com>wrote:
>>>>>
>>>>>> Hi all,
>>>>>>
>>>>>> I have configured MVA hairpin on BR1 router which is an MGCP gateway.
>>>>>> If the call is made to MVA route-pattern number [1999] from BR1 phone
>>>>>> then i hear "Welcome to Cisco Unfiied Communications"
>>>>>> If i call to MVA route-pattern number [1999] from HQ phone or PSTN
>>>>>> phone then i do not hear "Welcome to Cisco Unfied Communications". debug
>>>>>> shows the correct MVA dial-peer hits on BR1-GW.
>>>>>>
>>>>>> There is no transcoder configured on HQ or BR1 device pool. To
>>>>>> resolve my issue, if transcoder needs to be configured on HQ or BR1
>>>>>> device
>>>>>> pool then i would like to know why.
>>>>>>
>>>>>>
>>>>>> Here is the configuration:
>>>>>> MVA directory number: 1998
>>>>>> Route-pattern: 1999 <none> ----> BR1-H323-GW in BR1 device pool
>>>>>> BR1-MGCP-GW in BR1 devicepool
>>>>>> BR1 and HQ region talks g729
>>>>>>
>>>>>> Configuration from BR1-RTR:
>>>>>>
>>>>>> interface Loopback0
>>>>>> ip address 10.10.110.2 255.255.255.255
>>>>>> ip ospf network point-to-point
>>>>>> h323-gateway voip bind srcaddr 10.10.110.2
>>>>>>
>>>>>>
>>>>>> voice service voip
>>>>>> allow-connections h323 to h323
>>>>>> !
>>>>>> !
>>>>>> !
>>>>>> voice class codec 1
>>>>>> codec preference 1 g711ulaw bytes 160
>>>>>> codec preference 2 g729r8 bytes 20
>>>>>> !
>>>>>> !
>>>>>> !
>>>>>> voice class h323 1
>>>>>> h225 timeout tcp establish 3
>>>>>> !
>>>>>>
>>>>>>
>>>>>> voice translation-rule 1002
>>>>>> rule 1 /^1002$/ /4158884343/
>>>>>> !
>>>>>> !
>>>>>> voice translation-profile 1002
>>>>>> translate calling 1002
>>>>>> !
>>>>>> !
>>>>>> !
>>>>>> application
>>>>>> service mva http://10.10.210.10:8080/ccmivr/pages/IVRMainpage.vxml
>>>>>> !
>>>>>>
>>>>>> dial-peer voice 1997 voip
>>>>>> destination-pattern 1998
>>>>>> voice-class codec 1
>>>>>> voice-class h323 1
>>>>>> session target ipv4:10.10.210.11
>>>>>> dtmf-relay h245-alphanumeric
>>>>>> no vad
>>>>>> !
>>>>>> dial-peer voice 1998 voip
>>>>>> preference 1
>>>>>> destination-pattern 1998
>>>>>> voice-class codec 1
>>>>>> voice-class h323 1
>>>>>> session target ipv4:10.10.210.10
>>>>>> dtmf-relay h245-alphanumeric
>>>>>> no vad
>>>>>> !
>>>>>> dial-peer voice 1999 voip
>>>>>> translation-profile incoming 1002
>>>>>> service mva
>>>>>> voice-class codec 1
>>>>>> incoming called-number 1999
>>>>>> dtmf-relay h245-alphanumeric
>>>>>> !
>>>>>> ---------------------
>>>>>> output of debug voip dial-p
>>>>>>
>>>>>> Following output when called 1999 from BR1 extenstion 1002. I hear the
>>>>>> MVA message:
>>>>>> R1-RTR#
>>>>>> *Jun 15 11:23:22.838:
>>>>>> //-1/800CEF8C0B00/DPM/dpAssociateIncomingPeerCore:
>>>>>> Calling Number=1002, Called Number=1999, Voice-Interface=0x0,
>>>>>> Timeout=TRUE, Peer Encap Type=ENCAP_VOIP, Peer Search
>>>>>> Type=PEER_TYPE_VOICE,
>>>>>> Peer Info Type=DIALPEER_INFO_SPEECH
>>>>>> *Jun 15 11:23:22.838:
>>>>>> //-1/800CEF8C0B00/DPM/dpAssociateIncomingPeerCore:
>>>>>> Result=Success(0) after DP_MATCH_INCOMING_DNIS; Incoming
>>>>>> Dial-peer=1999
>>>>>> *Jun 15 11:23:22.838:
>>>>>> //-1/800CEF8C0B00/DPM/dpAssociateIncomingPeerCore:
>>>>>> Calling Number=1002, Called Number=1999, Voice-Interface=0x0,
>>>>>> Timeout=TRUE, Peer Encap Type=ENCAP_VOIP, Peer Search
>>>>>> Type=PEER_TYPE_VOICE,
>>>>>> Peer Info Type=DIALPEER_INFO_SPEECH
>>>>>> BR1-RTR#
>>>>>> *Jun 15 11:23:22.838:
>>>>>> //-1/800CEF8C0B00/DPM/dpAssociateIncomingPeerCore:
>>>>>> Result=Success(0) after DP_MATCH_INCOMING_DNIS; Incoming
>>>>>> Dial-peer=1999
>>>>>> BR1-RTR#
>>>>>> BR1-RTR#
>>>>>> BR1-RTR#
>>>>>> BR1-RTR#
>>>>>> BR1-RTR#
>>>>>> Following output when called 1999 from HQ extenstion 5002. I do
>>>>>> not hear the MVA message:
>>>>>> BR1-RTR#
>>>>>> BR1-RTR#
>>>>>> *Jun 15 11:23:34.346:
>>>>>> //-1/801A16940C00/DPM/dpAssociateIncomingPeerCore:
>>>>>> Calling Number=5002, Called Number=1999, Voice-Interface=0x0,
>>>>>> Timeout=TRUE, Peer Encap Type=ENCAP_VOIP, Peer Search
>>>>>> Type=PEER_TYPE_VOICE,
>>>>>> Peer Info Type=DIALPEER_INFO_SPEECH
>>>>>> *Jun 15 11:23:34.346:
>>>>>> //-1/801A16940C00/DPM/dpAssociateIncomingPeerCore:
>>>>>> Result=Success(0) after DP_MATCH_INCOMING_DNIS; Incoming
>>>>>> Dial-peer=1999
>>>>>> *Jun 15 11:23:34.346:
>>>>>> //-1/801A16940C00/DPM/dpAssociateIncomingPeerCore:
>>>>>> Calling Number=5002, Called Number=1999, Voice-Interface=0x0,
>>>>>> Timeout=TRUE, Peer Encap Type=ENCAP_VOIP, Peer Search
>>>>>> Type=PEER_TYPE_VOICE,
>>>>>> Peer Info Type=DIALPEER_INFO_SPEECH
>>>>>> BR1-RTR#
>>>>>> *Jun 15 11:23:34.346:
>>>>>> //-1/801A16940C00/DPM/dpAssociateIncomingPeerCore:
>>>>>> Result=Success(0) after DP_MATCH_INCOMING_DNIS; Incoming
>>>>>> Dial-peer=1999
>>>>>> BR1-RTR#
>>>>>> BR1-RTR#
>>>>>> BR1-RTR#
>>>>>>
>>>>>> Following output when called 4158881999 from PSTN phone 4158884343. I
>>>>>> do not hear the MVA message:
>>>>>> BR1-RTR#
>>>>>> *Jun 15 11:25:44.078:
>>>>>> //-1/808792E10D00/DPM/dpAssociateIncomingPeerCore:
>>>>>> Calling Number=1002, Called Number=1999, Voice-Interface=0x0,
>>>>>> Timeout=TRUE, Peer Encap Type=ENCAP_VOIP, Peer Search
>>>>>> Type=PEER_TYPE_VOICE,
>>>>>> Peer Info Type=DIALPEER_INFO_SPEECH
>>>>>> *Jun 15 11:25:44.078:
>>>>>> //-1/808792E10D00/DPM/dpAssociateIncomingPeerCore:
>>>>>> Result=Success(0) after DP_MATCH_INCOMING_DNIS; Incoming
>>>>>> Dial-peer=1999
>>>>>> *Jun 15 11:25:44.078:
>>>>>> //-1/808792E10D00/DPM/dpAssociateIncomingPeerCore:
>>>>>> Calling Number=1002, Called Number=1999, Voice-Interface=0x0,
>>>>>> Timeout=TRUE, Peer Encap Type=ENCAP_VOIP, Peer Search
>>>>>> Type=PEER_TYPE_VOICE,
>>>>>> Peer Info Type=DIALPEER_INFO_SPEECH
>>>>>> *Jun 15 11:25:44.078:
>>>>>> //-1/808792E10D00/DPM/dpAssociateIncomingPeerCore:
>>>>>> Result=Success(0) after DP_MATCH_INCOMING_DNIS; Incoming
>>>>>> Dial-peer=1999
>>>>>> BR1-RTR#
>>>>>>
>>>>>>
>>>>>> thanks
>>>>>> -adil
>>>>>>
>>>>>>
>>>>>> --
>>>>>> . . . .
>>>>>> _7___|___|_|_| adil.sha...@gmail.com
>>>>>>
>>>>>> . .
>>>>>>
>>>>>>
>>>>>>
>>>>>
>>>>>
>>>>> --
>>>>> . . . .
>>>>> _7___|___|_|_| adil.sha...@gmail.com
>>>>>
>>>>> . .
>>>>>
>>>>>
>>>>>
>>>>> _______________________________________________
>>>>> For more information regarding industry leading CCIE Lab training,
>>>>> please visit www.ipexpert.com
>>>>>
>>>>> Are you a CCNP or CCIE and looking for a job? Check out
>>>>> www.PlatinumPlacement.com
>>>>>
>>>>
>>>>
>>>
>>>
>>> --
>>> . . . .
>>> _7___|___|_|_| adil.sha...@gmail.com
>>>
>>> . .
>>>
>>>
>>>
>>
>
>
> --
> . . . .
> _7___|___|_|_| adil.sha...@gmail.com
>
> . .
>
>
>
> _______________________________________________
> For more information regarding industry leading CCIE Lab training, please
> visit www.ipexpert.com
>
> Are you a CCNP or CCIE and looking for a job? Check out
> www.PlatinumPlacement.com
>
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com
