If you test failover by stopping the ccm service, it is expected
If you shut down the wan ports the ports should register back
Enviado desde mi iPhone
El Jun 29, 2011, a las 21:06, <sandeep.ra...@wipro.com> escribió:
Hi All,
I have CUE in SRST mode and it works fine, but when i bring back
CUCM i dont see the CTI Route point and CTI ports getting registered
at all unless i reboot the CUE module.
Is this the way it normally behaves or am i unaware of some
configuration to fix this behaviour.
Also can you please jot down few points on how should i configure
CUE in SRST mode.
Thanks
Please do not print this email unless it is absolutely necessary.
The information contained in this electronic message and any
attachments to this message are intended for the exclusive use of
the addressee(s) and may contain proprietary, confidential or
privileged information. If you are not the intended recipient, you
should not disseminate, distribute or copy this e-mail. Please
notify the sender immediately and destroy all copies of this message
and any attachments.
WARNING: Computer viruses can be transmitted via email. The
recipient should check this email and any attachments for the
presence of viruses. The company accepts no liability for any damage
caused by any virus transmitted by this email.
www.wipro.com
_______________________________________________
For more information regarding industry leading CCIE Lab training,
please visit www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com
