Randall,
I believe the question is when going through the GUI initialization and it ask
for the IP address of CME, what IP address do you use?
Krishna,
Please correct me if I am wrong.
Sent from my iPhone
On Oct 20, 2012, at 9:06 PM, "Rrcrumm" <rrcr...@yahoo.com> wrote:
> The labs say to use an IP address if 10.10.115.2. So under the lo1 you need
> to add ip unnumbered lo1(also make sure to add the OSPG statement if needed
> and clear the ip OSPG process$
>
> Then add the IP address and default gateway.
>
> Then make sure to add the static route
>
> Hth
> Randall
>
> On Oct 20, 2012, at 2:25 PM, Krishna <vinayak_...@yahoo.com> wrote:
>
>>
>> when using loopback address for CUE setup, does it matter whether what ip
>> address we put it for cme in cue .i.e. for example loopback 10.10.115.1 or
>> 10.10.202.1(cme ip address)... it works in both the cases but just want to
>> make sure which one is the right way of doing it..
>>
>> thank you
>> krishna.
>> _______________________________________________
>> For more information regarding industry leading CCIE Lab training, please
>> visit www.ipexpert.com
>>
>> Are you a CCNP or CCIE and looking for a job? Check out
>> www.PlatinumPlacement.com
> _______________________________________________
> For more information regarding industry leading CCIE Lab training, please
> visit www.ipexpert.com
>
> Are you a CCNP or CCIE and looking for a job? Check out
> www.PlatinumPlacement.com
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com