Hi Bill, Thanks for your reply. I shall be therefore using the following config without using auto qos...
policy-map MQC-FRTS-768 class class-default shape average 729600 7296 0 ! Enables MQC-Based FRTS service-policy WAN-EDGE ! Queues packets headed to the shaper ! … ! interface Serial2/0 no ip address encapsulation frame-relay ! interface Serial2/0.12 point-to-point ip address 10.1.121.1 255.255.255.252 description 768kbps FR Circuit to RBR-3745-Left frame-relay interface-dlci 102 class FR-MAP-CLASS-768 ! ! … ! map-class frame-relay FR-MAP-CLASS-768 service-policy output MQC-FRTS-768 frame-relay fragment 960 ! Also I will be including the ... interface Serial2/0.12 point-to-point bandwidth 768 for the bandwidth requirement. Questions : 1) I shall be applying the a similar config on the branch router also. Is this correct? Is the above config adequate ? 2)There is also a branch 2 router . Does the config need to applied on the branch 2 even though it is not part of the requirement? 3) Are there any negative impacts of wan qos if the configuration goes incorrect? Thanks once again. -MJ On Tue, Dec 25, 2012 at 8:25 AM, Bill Lake <whl...@gmail.com> wrote: > Have you tried using the Cisco QOS SRND? > > http://www.cisco.com/en/US/docs/solutions/Enterprise/WAN_and_MAN/QoS_SRND/QoS-SRND-Book.html > > Look around at 3-27 > > On Mon, Dec 24, 2012 at 8:44 PM, sanity insanity < > networksanitytoinsan...@gmail.com> wrote: > >> hi Guys, >> >> Can you explain as to how we can achieve the following by ... >> >> Connecting HQ and a branch site is a 384 k frame relay PVC. Enable frf.12 >> Link frag and interleave >> the FR connection to fragment the large data packets and interleave the >> voice packets to >> minimize delays .Maximum delay between fragments should be set at 10ms >> .Also provision RTP >> header compression.We need to assume all bearer voice traffic has been >> marked with DSCP of "EF"and >> all of control traffic CS3. >> >> -MJ >> >> >> _______________________________________________ >> For more information regarding industry leading CCIE Lab training, please >> visit www.ipexpert.com >> >> Are you a CCNP or CCIE and looking for a job? Check out >> www.PlatinumPlacement.com >> > >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com