Hi, Check your WAN QoS It could be related to one way RTP compression. Regards Ramcharan Arya
On Sat, Feb 2, 2013 at 12:37 PM, Cory Gray <corygray22...@hotmail.com>wrote: > **** > > *You need to transfer h323 to sip on SiteC* > > Voice services voip**** > > Allow connections h323 to sip**** > > ** ** > > *Make sure your Site C Gwy register to Site A GK as H323-GWY instead of > VOIP-GWY* > > No gateway**** > > Gateway **** > > ** ** > > You do need a transcoder and it looks like you have it configured mostly > correct**** > > You do not need ephone 3**** > > Also it is a good practice to use version 6 or higher for sccp ccm > configuration or higher**** > > Also use bind interface X under sccp ccm group**** > > You should also not need “mailbox-selection last-redirect-num”**** > > ** ** > > ** ** > > *From:* ccie_voice-boun...@onlinestudylist.com [mailto: > ccie_voice-boun...@onlinestudylist.com] *On Behalf Of *Joe Fearday > *Sent:* Saturday, February 02, 2013 11:28 AM > *To:* ccie_voice@onlinestudylist.com > *Subject:* [OSL | CCIE_Voice] Site A to Site C can't leave vm on CUE**** > > ** ** > > Site A to Site C can't leave vm on CUE **** > > **** > > Site A to Site C configured for g729 > Site A routes to Site C using gk in region C > PSTN can leave vm on CUE as can other site C phones > I am thinking this is a site C transcoding problem > CUE only supports g711; right? > Site C transcoding detailed below along with ephone:**** > > **** > > sccp local Vlan102 > sccp ccm 10.196.102.1 identifier 1 version 3.1 > sccp > ! > sccp ccm group 1 > associate ccm 1 priority 1 > associate profile 1 register sctrans > ! > dspfarm profile 1 transcode > codec g711ulaw > codec g711alaw > codec g729ar8 > codec g729abr8 > codec g729r8 > maximum sessions 12 > associate application SCCP > > telephony-service > sdspfarm units 1 > sdspfarm transcode sessions 20 > sdspfarm tag 1 sctrans**** > > **** > > ephone 3 > codec g729r8 dspfarm-assist**** > > **** > > dial-peer voice 9000 voip > mailbox-selection last-redirect-num > destination-pattern 3180 (CUE) > session protocol sipv2 > session target ipv4:10.196.102.2 > dtmf-relay sip-notify > codec g711ulaw > no vad > > Any assistance is greatly apprecaited. > Joe Fearday**** > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com