Hi All,
I'm wondering about QoS on remote site.
I just applied auto-qos between HQ and remote site, everything looks fine.
When I run this command on both routers, in remote site I can't see packets.
HQ
Class-map: AutoQoS-VoIP-RTP-Trust (match-any)
11139 packets, 704260 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: ip dscp ef (46)
11139 packets, 704260 bytes
5 minute rate 0 bps
Priority: 47 kbps, burst bytes 1500, b/w exceed drops: 0
REMOTE
Class-map: AutoQoS-VoIP-RTP-Trust (match-any)
0 packets, 0 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: ip dscp ef (46)
0 packets, 0 bytes
5 minute rate 0 bps
Priority: 47 kbps, burst bytes 1500, b/w exceed drops: 0
For remote site I don't use HWIC-4ESW (expensive) instead am using ports from 3560 (same as HQ),
after I put the commands:
SW(config)#interface FastEthernet0/17
SW(config-if)#shut
SW(config-if)# mls qos trust device cisco-phone
SW(config-if)# mls qos trust cos
SW(config-if)#no shut
I started to see packets on policy-map.
Class-map: AutoQoS-VoIP-RTP-Trust (match-any)
186 packets, 11904 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: ip dscp ef (46)
186 packets, 11904 bytes
5 minute rate 0 bps
Priority: 47 kbps, burst bytes 1500, b/w exceed drops: 0
How I'll mark the packets on remote site to hit the policy-map in the FR link?
Thanks in advanced
Mendoza
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com