On 2015-08-07 18:22, Holm Tiffe wrote:
Hmm.. it seems that the pdf is containing thestuff that I've already read
somewhere on HP's website.
There are two possibilities:
[>>> B/R5:10000000 DKA400:
[
[
[If you are booting from an InfoServer device, enter a command that
[specifies root 1. For example, on a VAX 6000 computer, enter:
[
[
[>>> B/R5:10000100/X:D/B:6 ET0
[
Ok, the first should fit with an abbrevation:
B/R5:10000000 DUA3
(I have a VAX4000-300 not an VS4000/90, nor I have an VAX6000..)
and this boots until the message with the write protected disk
dua3..(sorry, don't have it handy..) and than the system hangs.
When I simply boot B dua3 the install system asks for a date
and I finally get a "$". Thats all..
That is all that is to be expected. Not sure what you were expecting,
but if you read the VMS installation manuals, you will see that this is
where you should end up.
And at this point, you run BACKUP to restore the initial saveset to a
disk, and then you boot that disk to continue.
That's why I've asked what todo..
And now you know. :-)
Johnny
Regards,
Holm
Jerry Weiss wrote:
Follow the OpenVMS VAX Version 7.3 Upgrade and Installation Manual
AA?QSBQD?TE
http://h20565.www2.hpe.com/hpsc/doc/public/display?docId=emr_na-c04623149&lang=en-us&cc=us
<http://h20565.www2.hpe.com/hpsc/doc/public/display?docId=emr_na-c04623149&lang=en-us&cc=us>
Section 3 takes you through the basics on how create a new disk. I used the
same procedure just last week.
Good Luck.
On Aug 7, 2015, at 10:26 AM, Holm Tiffe <h...@freibergnet.de> wrote:
Hi,
I've got an VAX4000/300 eqipped with an TK70, 2x RF31, 1xRF71 disks,
and an CQD-200/TM.
I've connected an toshiba Xm5701 drive to the SCSI Bus and the machine sses
it as DUA3. I have a VMS7.3 CDROM and want to install it on one of the
disks.
I've read some documents on HPs website but it isn't clear to me
how to boot the cdrom correctly, there is root 1 mentioned.
What bootflag must entered, B/R5:10000000?
..in the case w/o the R5:10000000 I get a $ Promt finally (here I habe to
read further). With the bootflag the System is complaining that dua3 is
write protected (it is the cdrom)...
What's the correct way to install VMS on that machine?
Regards,
Holm
--
Technik Service u. Handel Tiffe, www.tsht.de, Holm Tiffe,
Freiberger Straße 42, 09600 Oberschöna, USt-Id: DE253710583
www.tsht.de, i...@tsht.de, Fax +49 3731 74200, Mobil: 0172 8790 741
--
Johnny Billquist || "I'm on a bus
|| on a psychedelic trip
email: b...@softjar.se || Reading murder books
pdp is alive! || tryin' to stay hip" - B. Idol
