No Jerry, I don't think that the problems are related to the SCSI Bus or
the CDR. I can't write to the DSSI disks, that is the problem.
If thast problem persists I'll try to install to an additional SCSI disk
next..
Regards,
Holm
Jerry Weiss wrote:
> If the saveset restoration and the complex bootstrap both fail, suggest you
> investigate the following.
>
> 1) Make sure the SCSI bus that is used by the CD-ROM has proper termination
> and termination power.
>
> 2) Create/obtain a new image CD. Your image may be corruption or the CD-ROM
> may have trouble reading it.
>
>
>
>
> > On Aug 8, 2015, at 3:43 AM, Peter Coghlan <cct...@beyondthepale.ie> wrote:
> >
> > On Sat, 08 Aug 2015 at 08:21:07 +0200, Holm Tiffe <h...@freibergnet.de>
> > wrote:
> >
> >>
> >> I'm starting the image restore and now I have a problem that the DSSI disks
> >> are "not software enabled".
> >>
> >
> > I'm not sure but I think I recall getting that error when trying to mount a
> > disk that had media problems :-(
> >
> > It probably doesn't help much but the online help says this:
> >
> > VOLINV, volume is not software enabled
> >
> > Facility: SYSTEM, System Services
> >
> > Explanation: The volume valid bit is not set for the volume. All physical
> > and logical I/O operations will be rejected until the bit is
> > set.
> >
> > User Action: Check for a programming error. Verify that the volume is
> > mounted and loaded. Check to see that the power is on before
> > retrying the program.
> >
> > Regards,
> > Peter Coghlan.
--
Technik Service u. Handel Tiffe, www.tsht.de, Holm Tiffe,
Freiberger Straße 42, 09600 Oberschöna, USt-Id: DE253710583
www.tsht.de, i...@tsht.de, Fax +49 3731 74200, Mobil: 0172 8790 741
