I have a Qualstar 3412 that I've used with Depot4. I last used this on a 386 running DOS 6.22, a Trantor SCSI card and SCSIWorks! as the ASPI driver.
Travis On Thu, Feb 8, 2024 at 12:14 AM Nico de Jong via cctalk < cctalk@classiccmp.org> wrote: > > > >> Based on the comment in a message posted last fall, I downloaded and > >> installed the Overland Data Depot4 software that was mentioned during > >> a discussion of SCSI tape tools. But so far I've been stumped in > >> getting it to work. Basic system is a freshly set up Win98SE and an > >> Adaptec 1522 SCSI board connected to a Qualstar 9track. Depot4 > >> installs and runs without issue but when I try to point it at the > >> ASPI drivers it fails to recognize anything. Any suggestions on > >> where to look or what to tweak would be seriously appreciated! > > > The 34xx series has a SCSI - Pertec interface, so if you remove this > board, you have a Pertec drive. > > Thanks' > > Nico > > >