Hi, i assume either drive or media are bad resp. do not like each other.
> can read the iso with dvdisaster for example and > loop mount the iso. > The mediainfo tells me: > READ TRACK INFORMATION[#1]: > Track State: complete,damaged > Track Start Address: 0*2KB > Free Blocks: 0*2KB > Track Size: 1*2KB > dmesg tells me: > attempt to access beyond end of device > hdb: rw=0, want=68, limit=4 It seems that the data blocks were written but the media table-of-content was not correctly updated. In case of DVD-R this would be a failure to write the Recording Management Area before the media gets ejected. > Track State: complete,damaged The word "damaged" stems from the "Damage" bit of MMC command 52h READ TRACK INFORMATION. MMC-5 , 6.27.3.7 says: " The Damage bit, when set to one, and the NWA_V is set to zero; the track shall be considered not closed due to an incomplete write. The Drive may attempt an automatic repair when the CLOSE TRACK SESSION command is issued. Further incremental writing in this track is not possible. " NWA_V is set to zero, because if NWA_V is 1, then dvd+rw-mediainfo issues a line "Next Writable Address:" between lines "Track Start Address:" and "Free Blocks:". The failed or omitted operation is supposed to be performed by the drive when growisofs closes the track by 5Bh CLOSE TRACK/SESSION (which it usually does with DVD-R). Thus my assumption that your problem is a deterioration of the drive or some change in the media. > As far as I know, the kernel I did before > mounted my DVDs but when I know try to > boot it, they now fail too. Well, if really DVD-R which were mountable before are not mountable now, then it might be that the drive became unable to read the RMAs of DVD-R media. So try to read the media in other drives and try to read other DVD-R media with your drive. Have a nice day :) Thomas -- To UNSUBSCRIBE, email to [email protected] with a subject of "unsubscribe". Trouble? Contact [email protected]
