Never mind, I found them and will send them out to
all who wanted it.
Rich "66 Malibu ACES # 5066
----- Original Message -----
Sent: Wednesday, January 15, 2003 11:27
AM
Subject: Re: [Chevelle-List] blasting a
body
Well, I thought I knew where the instructions
were for the rotisserie. I'll find them this week end and send them to all who
wanted them.
Rich "66 Malibu ACES # 5066
----- Original Message -----
Sent: Wednesday, January 15, 2003 6:58
AM
Subject: Re: [Chevelle-List] blasting a
body
can i get those pics?
thanks
----- Original Message -----
Sent: Wednesday, January 15, 2003
6:46 AM
Subject: RE: [Chevelle-List] blasting
a body
I just finished building one. It was a piece of cake.
The steel was $178 all cut and ready to go. The worst part is
drilling all the holes. If you want pictures let me know. I
did make a little adjustment, added 2 hyd cyl to raise and lower it on the
uprights.
Jim Buckingham
Would you send those plans to a South Carolinan?
Smitty
----- Original Message -----
Sent: Tuesday, January 14, 2003
10:17 AM
Subject: Re: [Chevelle-List]
blasting a body
Kyle, If you want to build a rotisserie,
I have plans I can send you.
Rich "66 Malibu ACES #
5066
----- Original Message -----
Sent: Tuesday, January 14, 2003
9:41 AM
Subject: Re: [Chevelle-List]
blasting a body
what did you pay do have that
done?
Kyle Bennett
Raleigh, NC
----- Original Message -----
Sent: Tuesday, January 14,
2003 6:27 AM
Subject: Re: [Chevelle-List]
blasting a body
The fastest, safest and best way to
strip a car is acid dip. It will cost about the same as media
blasting. Maybe a little more. They don't use sand. Sandblasting
is one of those universal words everyone uses to describe what
they want done. They do sandblast the frame, I'll get mine done
this spring. Acid dipping will get in every nook and cranny and
remove EVERYTHING. Rust, grease, paint, sealer, etc. But you get
back virgin looking steel. They bake it in an oven to melt and
loosen everything then dip it and then it is run through a
neutralizing bath. Just had mine done and I couldn't be
happier with it. The solid floors I thought I had...... well their
not so solid. I have to replace two small sections in front. Right
where the air conditioner was. I had a Mustang media blasted once
and it turned out to be a nightmare. It will punch holes in weaker
metal even if there are no holes there now.
Rich "66 Malibu ACES #
5066
----- Original Message -----
Sent: Monday, January 13,
2003 12:26 PM
Subject: [Chevelle-List]
blasting a body
Typically, How much does it cost to
have a body sand blasted? I'm trying to decide if i want to rent
a Rotissorie (sp?) and do it my self, of just let somebody else
do it.
Thanks,
Kyle Bennett
Raleigh, NC
|