Me too Rich. Thank You
Richard Milkiewicz wrote:
Well,
I thought I knew where the instructions were for the rotisserie. I'll find
them this week end and send them to all who wanted them.Rich
"66 Malibu
ACES # 5066
----- Original Message -----
Sent: Wednesday, January 15, 2003
6:58 AM
Subject: Re: [Chevelle-List] blasting
a body
can i get those pics? thanks
----- Original Message -----
Sent: Wednesday, January 15, 2003
6:46 AM
Subject: RE: [Chevelle-List] blasting
a body
I
just finished building one. It was a piece of cake. The steel
was $178 all cut and ready to go. The worst part is drilling all
the holes. If you want pictures let me know. I did make a little
adjustment, added 2 hyd cyl to raise and lower it on the uprights.Jim
Buckingham
Would you send those plans to a South Carolinan? Smitty
----- Original Message -----
Sent: Tuesday, January 14, 2003 10:17
AM
Subject: Re: [Chevelle-List] blasting
a body
Kyle, If you want to build a rotisserie,
I have plans I can send you.Rich
"66 Malibu
ACES # 5066
----- Original Message -----
Sent: Tuesday, January 14, 2003 9:41
AM
Subject: Re: [Chevelle-List] blasting
a body
what did you pay do have that done? Kyle
BennettRaleigh, NC
----- Original Message -----
Sent: Tuesday, January 14, 2003 6:27
AM
Subject: Re: [Chevelle-List] blasting
a body
The fastest, safest and best way
to strip a car is acid dip. It will cost about the same as media blasting.
Maybe a little more. They don't use sand. Sandblasting is one of those
universal words everyone uses to describe what they want done. They do
sandblast the frame, I'll get mine done this spring. Acid dipping will
get in every nook and cranny and remove EVERYTHING. Rust, grease, paint,
sealer, etc. But you get back virgin looking steel. They bake it in an
oven to melt and loosen everything then dip it and then it is run through
a neutralizing bath. Just had mine done and I couldn't be happier
with it. The solid floors I thought I had...... well their not so solid.
I have to replace two small sections in front. Right where the air conditioner
was. I had a Mustang media blasted once and it turned out to be a nightmare.
It will punch holes in weaker metal even if there are no holes there now.Rich
"66 Malibu
ACES # 5066
----- Original Message -----
Sent: Monday, January 13, 2003 12:26
PM
Subject: [Chevelle-List] blasting
a body
Typically, How much does it cost
to have a body sand blasted? I'm trying to decide if i want to rent a Rotissorie
(sp?) and do it my self, of just let somebody else do it. Thanks,Kyle
BennettRaleigh, NC
|