RE: [Chevelle-list] intake mounted engine lift device

[Brian Zack]

The lifting tabs are bolted to the left rear 2 intake bolts & to the right front 2 intake bolts.     Brian Zack '70 Chevelle Malibu mailto:brianz@dpsabq.com   -----Original Message----- From: Dan McIntosh [mailto:[EMAIL PROTECTED] Sent: Thursday, September 11, 2003 2:06 PM To: The Chevelle Mailing List Subject: Re: [Chevelle-list] intake mounted engine lift device   the motor sits so far back in the early Impalas, it would be damn near impossible to get a lift tab on the back side of the engine...   Dan McIntosh Pavement Scraping 1964 Impala SS http://www.lowriderimpala.com ----- Original Message ----- From: [EMAIL PROTECTED] To: [EMAIL PROTECTED] Sent: Thursday, September 11, 2003 8:04 AM Subject: Re: [Chevelle-list] intake mounted engine lift device   In a message dated 9/11/2003 1:28:21 AM Eastern Daylight Time, [EMAIL PROTECTED] writes: I have been told its a no-no if you have a vortex intake, only 8 bolts. I always use the acc bolts in the heads, or the lifting tabs that come on the new crate motors. Good point about the lifting tabs. Seems like they were just leaving them on from the factory for quite a while. Should be easy to find on a junkyard engine. Pete Geurds 64 Malibu SS 64 Malibu 4 door 64 Chevelle 2 dr wagon