On Sat, Nov 17, 2007 at 10:33:43PM +0100, Daniel Roesen wrote: > At least it's configurable on global level, unlike "no ip proxy-arp" > and "no ip redirects" (and others). :-(
Slightly correcting myself here: there is "ip arp proxy disable" in some newer IOS trains which disables proxy-arp globally, and unfortunately overrides any interface configuration. So if you use this one, you cannot enable proxy-arp for a specific interface again. This is comparable to global "no cdp run" vs. the interface-level "(no) cdp enable". Unfortunately, "sh ip int" output is wrong: Router#sh run | i prox ip arp proxy disable Router#sh run int g0/1 | i prox Router#sh ip int g0/1 | i Prox Proxy ARP is enabled I've verified that proxy ARP is actually disabled. Just opened a TAC case for that. Also, "ip arp proxy disable" is - contrary to docs - not available in 12.2S (I tested on 12.2(25)S14 on 7500), but only 12.2SB (tested on 12.2(31)SB*). Best regards, Daniel -- CLUE-RIPE -- Jabber: [EMAIL PROTECTED] -- [EMAIL PROTECTED] -- PGP: 0xA85C8AA0 _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
