For supporting VPLS on a 7600, OSM or ES20 linecards are needed on the Core facing interfacces. Those cards will handle the label push and pop for SVI based interfaces.
You can use your defined hardware as a MPLS Access node and terminate your PW on a VPLS based 7600 router. This router must terminate the incoming PW's over a OSM or ES20 linecard. Cheers,, Dennis Dubbelman -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of MKS Sent: dinsdag 29 januari 2008 15:02 To: cisco-nsp@puck.nether.net Subject: [c-nsp] c7600 and VPLS Hi I'm a bit confused about hardware support for VPLS and cisco 7600. If I have only LAN cards e.g. 6724 customer facing and 6704 core facing does that mean that I have no VPLS support or just not H-VPLS ? Can I run some topology of VPLS with only LAN cards (full mesh, hub-spoke, partial mesh). Regards MKS _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/