Just to make sure I'm clear: "802.1p value for packets going out from Gig2/1 is set to 0" - I mean packets received from Gig2/1, going to the Linux box on another interface, have CoS bits set to 0, despite "mls qos cos 5" on the Gig2/1. The sniffer is running on the Linux box.
On Sun, Feb 10, 2008 at 12:31:37AM +0200, Vladimir Ivashchenko wrote: > Hi List, > > We cannot get Cat6500 to rewrite CoS values (802.1p bits). > > Configuration is > > mls qos > no mls flow ip > no mls flow ipv6 > no mls qos rewrite ip dscp > no mls acl tcam share-global > mls cef error action freeze > > interface GigabitEthernet2/1 > switchport > switchport trunk encapsulation dot1q > switchport mode trunk > no ip address > load-interval 30 > wrr-queue queue-limit 40 30 > mls qos cos 5 > no cdp enable > spanning-tree portfast trunk > no mls qos trust > > We have a sniffer connected to dot1q trunk on another port. The sniffer shows > that 802.1p value for packets going out > from Gig2/1 is set to 0. We have tried searching Cisco site and playing with > various commands, but did not succeed. IOS > 12.2(18)SXF5. > > Catalyst 3560 has "mls qos cos override" command, which seems to do the > trick, but this command is not available on > Catalyst 6500. > > -- > Best Regards > Vladimir Ivashchenko > Chief Technology Officer > PrimeTel, Cyprus - www.prime-tel.com > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ -- Best Regards Vladimir Ivashchenko Chief Technology Officer PrimeTel, Cyprus - www.prime-tel.com _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
