Hi Vladimir, The "mls cos cos 5" command is only used for frames without an existing .1p tag, like frames from the native VLAN in a trunk or frames from an access port.
I think the Cat6500 has the "override" keyword, so you can add the line "mls qos cos override", which should do what you want, i.e. setting CoS 5 for all packets arriving at the port. IMHO a service policy would be the best way to do it though, as Arie mentions. Regards, Peter On Sun, 2008-02-10 at 00:31 +0200, Vladimir Ivashchenko wrote: > Hi List, > > We cannot get Cat6500 to rewrite CoS values (802.1p bits). > > Configuration is > > mls qos > no mls flow ip > no mls flow ipv6 > no mls qos rewrite ip dscp > no mls acl tcam share-global > mls cef error action freeze > > interface GigabitEthernet2/1 > switchport > switchport trunk encapsulation dot1q > switchport mode trunk > no ip address > load-interval 30 > wrr-queue queue-limit 40 30 > mls qos cos 5 > no cdp enable > spanning-tree portfast trunk > no mls qos trust > > We have a sniffer connected to dot1q trunk on another port. The sniffer shows > that 802.1p value for packets going out > from Gig2/1 is set to 0. We have tried searching Cisco site and playing with > various commands, but did not succeed. IOS > 12.2(18)SXF5. > > Catalyst 3560 has "mls qos cos override" command, which seems to do the > trick, but this command is not available on > Catalyst 6500. > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
